您要查找的是不是：
- annealing temperature range 退火温度范围
- For service temperature range and a skid-proof surface see Remarks. 可耐温度范围及防滑表面见备注。
- The influences of different annealing temperature on the structure and hardness was compared and investigated.The proper annealing temperature for the bainite nodular iron roller ring was proposed. 对比研究了不同退火温度对贝氏体球铁辊环组织和硬度的影响，提出了贝氏体球铁辊环合适的退火温度。
- In this wide temperature range, even in a severe environment. 能在更大的温度范围,甚至恶劣的环境中工作。
- The temperature ranges between 30 and 40 degrees centigrade. 温度在摄氏三十度与四十度之间。
- The operating temperature range is from -40 deg.C to 74 deg.C. 工作范围为负40摄氏度至74摄氏度。
- When annealing temperature is above 750 degrees centigrade, it is very ease for a-Si:H thin films to crystallize. 沉积a-Si：H薄膜时的衬底温度越高，得到的a-Si：H薄膜越容易晶化。
- The article introduces a way to confirm suitable annealing temperature of the aluminum alloy. 介绍了一种试验确定铝合金适宜退火温度的方法。
- The temperature ranges from zero to ten degrees. 气温在零至十度之间。
- The effects of annealing temperature on electrochemical performances of the alloy were investigated. 研究了退火温度对合金的电化学性能的影响。
- Climatic conditions, e.g. max. temperature range, humidity, air density. 气侯情况，如：最大温度范围，湿度，空气密度
- Results In PCR, the primer for internal reference gene, content of dNTP, and runing cycles affect the products much than the annealing temperature. 结果在pcr反应中,扩增内参照和目的基因的引物比例、底物浓度以及pcr反应的循环次数对产物的影响较大,而退火温度的影响较小。
- The temperature ranges from ten to thirty degrees. 气温在十至三十度之间。
- The present work is to investigate the effect of annealing temperature Tan on microst-ructure and superstructure of HEPP fibers by FRS-XRSA and SAXS. 本文是继应用WAXD与SAXS研究退火时间对HEPP结构影响后的第二部分工作,即退火温度的影响。 结果指出:FRS-XRSA是研究择优取向聚合物结晶与取向的合理方法;
- The variation of the dangling bonds with annealing temperature in a-Si: F produced by ion implantation is measured by EPR. 本文用电子顺磁共振(EPR)测量了离子注入a-Si:F中悬键密度随退火温度变化的关系。
- With the increasing of anneal temperature, the resistance of P-implanted TiO2 thin films decrease and their water contact angles fluctuate at 70? 随着退火温度的上升;P注入的TiO2薄膜材料电阻降低;与水的接触角在70度左右波动.
- The variation of Ni/Ge structure on different orientation substrate as a function of annealing temperature will be shown and discussed. 我们将说明在不同方向的锗基底上会随不同退火之温度而形成不同镍锗化合物并讨论之。
- At the same time, the crystallite size increases and interplanar distance decreases with the increase of annealing temperature. 同时，随着退火温度的升高，晶粒尺寸长大，晶面间距降低。
- It was found the annealing temperature and structure of PP-g-PEG had effect on the diffusion and selective aggregation in PP. 实验发现：温度和分子结构对接枝共聚物在聚丙烯改性体系中的扩散存在影响。
- Dropping Point of Lubricating Grease of Wide Temperature Range, Method of Test for (05. 大温度范围的润滑脂的滴定点的试验方法(05。
