您要查找的是不是：
- air cylinder valve gland 气筒阀压盖
- air cylinder valve bonnet 气筒阀帽罩
- air cylinder valve 气筒阀
- air cylinder valve plug 气筒阀塞
- air cylinder valve stem 气筒阀杆
- Peumatic element and main air cylinder are importation and Yadeke. 气动元件及主要动作气缸为进口和亚得克。
- The squeegee and cover ink blade controlled by the air cylinder. 刮、回墨的互换动作均由气缸控制。
- Open the hand-operated air valve(3),air cylinder(2),i.e.Tightly press the Machining aluminium materials,shut(3),then loosen is. 打开手动气阀(3);气缸(2)即压紧加工件;关闭(3);手动阀则松开.
- The stove and cylinder valve's copulae, use tie-in double pressurize device. 卡炉与气瓶阀门的接合部位采用接头双重密封装置。
- Guarantee the engine air cylinder, spark plug and oil passage are cleaned. 保证发动机气缸,火花塞和油路清洁。
- If user experiences any difficulty operating cylinder valve discontinue use and contact supplier. 如果使用者在操作气瓶阀时有困难,需停止使用,并与供应商联系。
- This valve is used at the end of long pipes to make the brake chamber full of compressed air in the air cylinder quickly and lessen the braking responding time and air pressure setting up time. 此阀用于长管路的末端，使储气筒的压缩空气快速充满制动气室，从而了缩短制动反应时间和气压建立时间。
- An acetylene cylinder valve should not be opened more than approximately1 1 /2 turns. 乙炔钢瓶阀门不能开启得超过大约11/2圈。
- Always pressurize a regulator slowly, while standing with the cylinder valve between you and the regulator. 总是站得使钢瓶阀门位于你和调整器之间，对调整器慢慢加压。
- Duplex turret type unwinder and rewinder, pre-drive with pre-tension for non-stop shaft exchange. It used shaftless air cylinder. 收放卷采用双工位翻黑心架，并实现翻工位不停机全自动裁切，均采用无轴气顶（可选择气胀轴）。
- Always open a cylinder valve slowly. Never crack open a hydrogen cylinder to clear the valve of dust, as the escaping hydrogen may ignite. 总是慢慢地开启钢瓶阀门。由于溢出的氢可能着火，禁止啪地一声打开氢钢瓶。
- Combine your basic BD Compact with an air cylinder of your choice, and the face mask best for your requirements. 结合你的与你的选择的汽缸,以及最有利于你的要求的面罩紧密的基本的BD。
- At the end of the shift or work day, close the cylinder valve and bleed the pressure off the regulator and torch equipment. 在下班或工作日结束的时候，关闭钢瓶阀门，放出调整器和吹管设备内的压力。
- It uses air cylinder to control tightness degree of rewinding, which is reliable and convenient in operation. 采用气缸压控复卷松紧度，控制可靠，操作方便。
- Recommended Closing Procedure: Close the cylinder valve tightly using a gloved hand. 推荐的关闭程序：用戴手套的手紧紧地关闭阀门。
