您要查找的是不是：
- WIPER AND WASHER SYSTEMS 雨刷和清洗器系统
- Motor vehicles--Windshield wipers and washer systems--Performance requirements and test methods 汽车风窗玻璃刮水器、洗涤器的性能要求及试验方法
- Using an ohmmeter, check the rear wiper and washer switch continuity at the switch terminals as follows: 用欧姆表，按下述程序，对开关端子处的后雨刷和清洗器开关的导通性进行检测。
- AC film capacitor in elrctric fan and washer etc. 电风扇、洗衣机家电用交流电容器。
- The windshield wiper and washer switch cannot be repaireIf any function of the switch is faulty, or if the switch is damaged, the entire switch unit must be replace 挡风玻璃雨刷和清洗开关是不可维修的。如果开关的任何功能发生了故障，或者如果开关损坏了，必须更换整个开关。
- WINDSHIELD WIPER AND WASHER 挡风玻璃雨刷和清洗器
- Hold the yoke with Wrench 67Remove the pinion shaft nut and washer. 用扳手6719握住轴轭。拆下小齿轮轴螺帽和垫圈。
- Remove vibration damper bolt and washer from end of crankshaft. 从曲轴端拆下减震器螺栓和垫圈。
- Disconnect wire harnesses and washer hose from liftgate. 从升降闸门上断开线束和清洗器软管。
- Electrical contact is maintained between the wiper and resistance element. 滑臂与电阻器之间形成一个电接触点。
- Use ST4.2 screws to fix the clothes rack and washer on the wall. 用ST4.;2螺丝将主体和螺纹垫圈一起固定在墙面上。
- Use care not to score the housing bore when prying out seals and washer. 当拆下油封和垫圈时，要特别小心切勿划伤机座孔。
- Disconnect the washer supply hoses from the barbed nipples on each end of the rear washer system check valve. 从在后清洗器系统止回阀的每边上的带挂钩螺纹接头上断开清洗器供应软管。
- A basic pressure washer system consists of a drive, pump, regulator/unloader, hose, gun, wand, and a nozzle. 一套基本的高压清洗机系统包括了驱动装置，泵，压力调节器/减荷器，软管，水枪，枪杆和喷嘴。
- The wipers and rain repellent are used for providing clear vision. 雨刷和防雨剂用来提供清晰视野。
- REPAIR OPEN WASHER PUMP CONTROL CIRCUIT BETWEEN THE BCM AND WASHER PUMP. 修改BCM和清洗泵之间歇路的清洗泵控制电路。
- Relevant machines for automatic trimmer series,including automatic thread trimmer,auto reverse,wiper and auto lifter. 延伸机种，可函盖所有自动切线型的各种功能（自动切线，倒缝，拨线，抬压脚）
- Rear wiper with intermittent feature and washer jet 后间歇雨刷+雨刷喷水头
- Use: Spray this product evenly on dust wiper and keep it for8-10 hours, and then it can be used, shake the dust off your dust wiper after use. 使用方法：将本品均匀喷涂尘推上，待8至10小时干后，即可使用，每次用完，将灰尘抖净。
- Use: Spray this product evenly on dust wiper and keep it for 8-10 hours, and then it can be used, shake the dust off your dust wiper after use. 使用方法：将本品均匀喷涂尘推上，待8至10小时干后，即可使用，每次用完，将灰尘抖净。
