您要查找的是不是：
- Defines a single parameter in the current method. 在当前方法内定义一个参数。
- Gets the root lexical scope for the current method. 获取当前方法的根词法范围。
- The current method is not generic. 当前方法不是泛型。
- Defines a group of sequence points within the current method. 在当前方法内定义一组序列点。
- Our current methods of production are too expensive. 我们现今用的生产方法太花钱了。
- FEM is the main method of the current method in bellow designing. 如何设计出结构合理的波纹管以保证降噪效果具有一定的理论和实际意义。
- Gets the start and end positions for the source of the current method. 获取当前方法的源的起始和结束位置。
- Describes the chain of callers leading up to the current method call. 描述调用方链,该链最终导致当前方法调用。
- The calling convention, number and type of arguments at the destination address must match that of the current method. 位于目标地址的参数的调用约定、数目和类型必须与当前方法的这些项匹配。
- The evaluation stack for the current method must be empty except for the value to be returned. 当前方法的计算堆栈必须为空,只有要返回的值除外。
- If the end of the stream is reached before count of characters is read into buffer, the current method returns. 如果在将count个字符读入buffer之前已到达流的末尾,则当前方法将返回。
- The specified method becomes the current method for calls to define sequence points, parameters, and lexical scopes. 指定的方法成为用于调用的当前方法,目的是定义序列点、参数和词法范围。
- Prefix instruction to specify that the current method state should be released before transferring control. 指令之前,以指定转移控制之前应释放当前方法状态。
- In this paper,the relation of evaporator temperature and heating current has been investigated and discussed. 本文通过实验研究了蒸发舟温度与加热电流的关系,并对结果作了分析。
- The analysis indicated that the current method for machining the abnormal deep ostiole has many drawback. 结果表明,当前异形深小孔的加工技术存在诸多缺陷。
- Repeating your current actions will get you the same end results. If the current method is ineffective, change it. 重复目前的做法,只会得到目前的结果。如果现行方法无效,就要改用其它方法。
- The knock and misfire of the engine are detected by ion current method which is a new way of engine diagnosis. 用离子电流法检测到了发动机爆震和失火的故障现象,为发动机故障诊断提供了一种新的方法;
- Heat sometimes causes a prickly rash on the skin. 热有时使皮肤上生剌痛的疹子。
- The process parameters of electric upsetting include: velocities of upsetting cylinder and anvil cylinder, heating current, preheating length and time, etc. 电热镦粗成形过程的工艺参数主要包括镦粗缸活塞运动速度、砧子缸活塞运动速度、镦粗压力、加热电流和预热长度等。
- The system works on the principle that heat rises. 该项装置是按照热力上升的原理运转的。
