您要查找的是不是：
- Parking Brake Mechanism 停车制动器机构
- Adjust parking brake cable tensioner. 调节手煞车钢索拉伸器。
- Adjust parking brake front cable. 调节手煞车前钢索。
- Install parking brake lamp switch. 安装手刹车灯开关。
- Make sure the parking brake is fully set. 确保手刹完全拉上。
- Connect parking brake cable to brackets and lever. 连接到支架和操纵杆的团刹车钢索 。
- He pulls the parking brake lever up. 更清楚了，是拉上那个手刹的“杆”！
- Connect light green lead to parking brake switch lead of car. 连接浅绿色导线到汽车的剎车开关导线。
- Loosen parking brake cable adjustment nut until there is slack in front cable. 放松手刹车钢缆调整螺帽直到前钢缆松弛。
- The structure and the mechanism for the electric park brake (EPB) were analyzed first.Then, the dynamical analysis for the executive device of EPB was done. 在对电子驻车制动系统的结构和工作原理进行分析的基础上，对电子驻车制动系统执行机构进行了动力学分析。
- The parking brake is also electronic and is located on the dashboard. 电子停车制动系统。
- Start the engine, then press the brake pedal and release the parking brake. 发动机点火,然后踩下制动踏板并松手刹。
- If you do drive a car, DO NOT pull the emergency parking brake at a stoplight. 如果你是在驾车行驶的话，在停车等亮的时候不要拉紧急刹车。
- SECURITY. Reverse alarm, neutral start switch, handlever parking brake. 安全性：倒车报警器，空挡开关，手动驻车制动。
- Travel mechanism of each track consists of a variable two-speed piston motor, a planetary reducer and a parking brake, travel brake buffer valve is mounted on motor to reduce hydraulic shock. 每侧履带的行走机构由一个变量双速柱塞马达、行星减速器和制动器组成,行走制动缓冲阀与马达一体安装,吸收了行车时由于制动或载荷变化带来的液压冲击。
- By analysis and comparison,a new driving mechanism of parking brake is self-designed,which can guarantee the equal cable pulling force in both right and left rear cables by turning of the balancer. 通过分析与对比，自行设计了一种新型驻车制动传动机构，该结构可通过平衡器的转动保证左、右后拉索拉力相等。
- RELEASE THE PARK BRAKE, DISCONNECT THE BRAKE FLUID LEVEL SWITCH CONNECTOR. 放开手煞车，断开煞车油液位高开关接头。
- DISCONNECT THE ABS WARNING LAMP DIODE, LOCATED ABOVE THE PARK BRAKE ASSEMBLY. 断开位于手刹车上方的ABS警示灯二极管。
- Insert front cable through the parking brake lever basInsure the cable retainer is seated into the base. 将前钢缆穿过手刹车拉杆底座。钢缆扣件务必啮合到底座。
- Units with automatic braking, brake mechanism locking weeks after separating unit displacement, maintain printer spaces. 机组设有自动刹车机构，机组分离后刹车机构锁紧周向位移，保持印刷机位。
