您要查找的是不是：
- PIT and PLT adjusting knob. 调节旋钮。
- The regulating handle is fitted with a fine speed adjust knob and a latch. 调节手柄配有一个细的速度调整旋扭一个锁销。
- Study of Two Methods For Pit and Fissure Sealing. 窝沟封闭剂的封闭性研究
- Sometimes I go to the gravel pit and roll around in the sand. 有时我会到沙坑里在沙里翻滚取乐。
- They'd dug a shallow pit and left the rubbish in it. 他们挖了一个浅坑把垃圾扔在了里面。
- Go down the sand pit and dig for the bones of stegosaurus! 快到大沙坑里挖掘剑龙的骨头吧。
- The volume adjustment knob on my TV is broken. 我电视机上的音量调节开关坏了。
- Emphasis: the treatment procedure of Pit and Fissure Sealant. 重点：窝沟封闭技术的治疗步骤。
- To clean strainer or replace seat/stem module shut off supply, loosen knob retaining screw and back off adjusting knob. 要清洗过滤器或更换阀座/阀杆模块，先关闭供应管道，松开旋钮固定螺丝并且将调节旋钮退出。
- They have silenced me in the pit And have placed a stone on me. 他们使我的命在牢狱中断绝、并将一块石头抛在我身上。
- The frequency used in experiments was set at 20.3 kHz (controlled through the adjusting knob). 频率被使用在实验被设置了在20.;3 千赫(被控制通过调整的瘤) 。
- Always depressurize a regulator before closing the adjusting knob and removing the regulator from the cylinder. 在关闭调整钮和从钢瓶上断开调整器之前，总是使调整器减压。
- Close the regulator. After relieving all the gas pressure, turn the adjusting knob counter clockwise as far as it will go. 关闭调整器。在释放了所有的气体压力之后，逆时针旋死控制钮。
- Close the regulator. To close the regulator, turn the adjusting knob to the full counter-clockwise position. The regulator must be closed before opening the cylinder valve. 关闭调整器。要关闭调整器，把调整钮逆时针旋死。在开启钢瓶阀门之前，必须关闭调整器。
- Turn the adjusting knob clockwise and establish the required use pressure by referring to the low-pressure gauge. Make sure that the cylinder valve is easily accessible. 顺时针旋转调整钮，通过查看低压量表建立要求的使用压力。确认钢瓶阀门容易接近。
- Methods We measured MPV and PLT in 105 consecutive type 2 diabetic patients and 90 nondiabetic control subjects. 方法选取2型糖尿病患者105例和健康对照组90例,分别测定血小板数(PLT)、血小板平均体积(MPV)、空腹血糖。
- The wood is full of pits and needs sanding. 这木料上到处是凹坑, 需用砂纸打磨一下。
- For slower rebound, turn the red adjuster knob clockwise. 顺时针转动红色调节钮以减慢回弹速度。
- Check diaphragm regulators for creep (leakage of gas from the high-pressure to the low-pressure side when the adjusting knob is turned fully counterclockwise). 检查隔膜调整器是否有漂移（如果调整钮逆时针方向旋死的话，会出现从高压端到低压端的气体泄漏）。
- WBC and PLT counts were increased 24 hour later(P<0.05) and returned to normal in 38 and 39 respectively three months later. 术后24h白细胞和血小板计数开始升高(P<0.;05);术后3个月白细胞维持在正常值为38例;血小板维持在正常值为39例。
