您要查找的是不是：
- Connect light green lead to parking brake switch lead of car. 连接浅绿色导线到汽车的剎车开关导线。
- If the parking brake switch cord is too thin, connect the parking cord to the parking brake switch cord directly without using the tap. 如果剎车开关导线太细,则不要使用分接头,直接把停车线连到剎车开关导线。
- Be sure to connect the parking cord (Light green) to the parking brake switch cord. The mounting position of the parking brake switch cord depends on your car. 务必把停车线(浅绿色)连到剎车开关导线上,剎车开关导线的固定位置和您的汽车有关。
- Install parking brake lamp switch. 安装手刹车灯开关。
- PARKING BRAKE SWITCH 手煞车开关
- The BCM uses inputs from the parking brake switch and the brake warning switch to decide whether the brake warning lamp should be on or ofThe BCM then sends the proper message to the instrument cluster on the CCD data bus to turn the lamp on or of BCM使用从手煞车开关和煞车警告开关接收到的消息来确定煞车警示灯的开关状态。然后，BCM向位于克莱斯勒碰撞检测（ccd）资料母线上的仪表组发送相应的消息，打开或关闭煞车警示灯。
- Adjust parking brake cable tensioner. 调节手煞车钢索拉伸器。
- SECURITY. Reverse alarm, neutral start switch, handlever parking brake. 安全性：倒车报警器，空挡开关，手动驻车制动。
- Adjust parking brake front cable. 调节手煞车前钢索。
- Make sure the parking brake is fully set. 确保手刹完全拉上。
- Connect parking brake cable to brackets and lever. 连接到支架和操纵杆的团刹车钢索 。
- He pulls the parking brake lever up. 更清楚了，是拉上那个手刹的“杆”！
- RELEASE THE PARK BRAKE, DISCONNECT THE BRAKE FLUID LEVEL SWITCH CONNECTOR. 放开手煞车，断开煞车油液位高开关接头。
- Loosen parking brake cable adjustment nut until there is slack in front cable. 放松手刹车钢缆调整螺帽直到前钢缆松弛。
- The parking brake is also electronic and is located on the dashboard. 电子停车制动系统。
- Start the engine, then press the brake pedal and release the parking brake. 发动机点火,然后踩下制动踏板并松手刹。
- The unit consists of auto air brake switch, commutation transformer, commutation unit, direct current contactors. 整个控制柜由自动空气开关、整流变压器、整流单元、直流接触器等主要部件构成；
- If you do drive a car, DO NOT pull the emergency parking brake at a stoplight. 如果你是在驾车行驶的话，在停车等亮的时候不要拉紧急刹车。
- DISCONNECT THE ABS WARNING LAMP DIODE, LOCATED ABOVE THE PARK BRAKE ASSEMBLY. 断开位于手刹车上方的ABS警示灯二极管。
- Insert front cable through the parking brake lever basInsure the cable retainer is seated into the base. 将前钢缆穿过手刹车拉杆底座。钢缆扣件务必啮合到底座。
