您要查找的是不是：
- SYS driver to place the Ethernet Interface Card in promiscuous mode to capture all the packets that travel through the network. SYS驱动设置以太网接口卡为混杂模式，用来捕获所有网络上的数据包。
- This paper describes the implementation method and technology of ethernet interface card based on USB BUS. A 10BASE-T ethernet adapter based on USB1.1 protocol has been designed. 论述了基于USB总线的以太网接口卡的实现方法和技术;设计开发了符合USB1.;1协议的10BASE-T以太网接口卡
- Ethernet Interface Card Based on USB Technology 一种基于USB总线的以太网接口卡技术
- Ethernet interface card 以太网接口插件板
- The Ethernet Interface Design Of Networked Intelligent Sensor. 网络化智能传感器中以太网接口设计。
- Test using the IP address of your computer network interface card. 请使用您的计算机网络接口卡的IP地址进行测试。
- Taking the application of embedded EEPROM designed in the ethernet network interface card as an example,a typical design method for the application of interface and control circuit of series EEPROM in embedded system was introduced. 本研究以以太网接口卡芯片中EEPROM的嵌入式应用开发为例,介绍和提供了一种嵌入式系统中串行EEPROM的接口和控制电路的设计方法。
- It implements a routine to analyze the important protocols in the TCP/IP protocol stack,such as Ethernet,IP,TCP,UDP and HTTP,on the basis of the Winpcap library and its BPF mechanism to capture and filter data on the network interface card. 在讨论Winpcap函数库和其中的BPF过滤机制的基础上,实现了对Ethernet,IP,TCP,UDP,HTTP等主要协议的分析。
- Suppose you want to configure an Ethernet interface such that it has a fixed IP address of 192.168.0.111. 假设你要配置一个以太网接口;使其拥有一个固定的IP地址192.;168
- Because, it needs to manufacture the interface card, the cost will be high. 由于需要制作适配卡,所以成本高昂。
- Ethernet interface circuit is realized using net-card chip RTL8019AS, and Ethernet data transmition function is realized using simplex TCP/IP protocol. 利用网卡芯片RTL8019AS完成以太网硬件接口电路,采用精简的TCP/IP协议来完成以太网的数据传输功能;
- It could be that your Network Interface Card provides TFTP boot functionality. 您的网卡很有可能提供了TFTP引导功能。
- This is listening with software to the Ethernet interface for packets that interest the user. 用软件在以太网接口聆听对使用着感兴趣的包。
- A gigabit Ethernet interface makes sure that data from external sources is also transferred at a high rate. 一个吉比特以太网界面可保证数据从外部进入时仍处于高速状态。
- If cabling is correct, power off the device and reseat the interface card. 假如缆线连接是正确的，关掉设备且重新插入介面卡。
- A subinterface is a logical interface within a physical interface, such as the Fast Ethernet interface on a router. 一个子界面是在一个实体界面(例如：路由器上的高速乙太网路界面)上的逻辑界面。
- The system can be managed via Modbus Ethernet interface in order to grant reliability and total safety, even without personnel on-site. 为了提供可靠性和整个安全性,该系统可以通过。
- Verify that the Ethernet interfaces are up and configured correctly. 验证以太网接口已经启用并且配置正确。
- The numbers under the ETH alarm indicates the Ethernet Interface Node Ring Node Address: Link Node Group & Link Node Member. ETH 告警下面的号码表示以太网接口节点环节点地址：链路节点群以及链路节点成员。
- This section describes the relationship between the Ethernet Interface Node (EIN) and EINLINK status indicators and alarms. 这一节将描述以太网接口节点 (EIN) 与 EINLINK 状态指示器和告警之间的关系。
