您要查找的是不是：
- Study on Bend Elastic Modulus of Ceramic Shell in Investment Casting 熔模铸造型壳抗弯弹性模量的研究
- Test of bending elasticity modulus of lean concrete 贫混凝土基层材料弯拉弹性模量的试验
- Bending elastic modulus 弯曲弹性模量
- Regular results were achieved from these tests.Compared with the static test, the bending strength, initial elastic modulus and crazing straining were larger in dynamic test. 通过对全级配混凝土构件的静动态弯拉试验，得出了有规律的成果。
- Keywords Epoxy resin;Changed-amide;Flexibilizer;Shear strength;Bending elasticity modulus;Bend strength;SEM; 环氧树脂;改性胺;增韧剂;剪切强度;弯曲强度;弯曲弹性模量;扫描电镜;
- The bonding strength between the substrate and the coating,the bending,the compressing,tensile strength and elastic modulus of the coating were also determined. 结果表明,稀土能够提高涂层与基体的结合强度、抗弯及抗拉强度,但降低了涂层的抗压强度。
- The experimental results showed that the elastic modulus in tension and bending reaches the optinal value when the ratio between braided yarns and axial yarns is 50/50 and 75/25. 在交织纱和轴纱的比例分别为50/50和75/25时，材料的拉伸弹性模量和弯曲弹性模量达到最佳值。
- The static elastic modulus of the alloy is lower than 30 GPa. 合金的静态弹性模量小于30GPa;
- According to elastic modulus of bending strength, ratio of knot and diameter, grain slope, yearly ring width and the wood defects of crackle, rot, discor, determinating indexes of board grade of small diameter larch. 根据抗弯弹性模量、节径比、纹理斜度、年轮宽度和裂纹、腐朽、变色等木材缺陷,确定小径落叶松层板等级。
- The properties of compression strength, bending strength, tensile strength, binding strength and elastic modulus of epoxy mortar modified with flexibilizer and fiber have been studied. 研究了掺增韧剂和纤维进行改性的环氧砂浆抗压、抗弯、抗拉、粘结及弹性模量等性能。
- Bending elasticity modulus 弯曲强度
- Two series of fatigue crack growth rate (FCGR) tests using three point bend specimen with different integral knife edge designs are performed. Effect of elastic modulus on the measurement of fatigue crack length using compliance technique is analyzed. 用不同整体刀口设计的三点弯曲SE(B)试样做了两组疲劳裂纹扩展速率 (FCGR)试验 ,分析了弹性模量在柔度法测量疲劳裂纹长度中的影响。
- The various types of stress, strain, and elastic modulus are summarized in Table 10-3. 各种应力、应变和弹性模量列于表10-3中。
- The larger the elastic modulus, the greater the stress needed for a given strain. 弹性模量越大，产生一定应变所需要的应力也越大。
- The ratio of stress to strain, or the stress per unit strain, is called an elastic modulus of the material. 应力与应变之比，即每单位应变的应力，叫做该材料的弹性模量。
- However, the elastic modulus of SCC is not significantly affected by S/A ratio when total aggregate volume is kept constant. 然而对弹性模数而言，当骨材总体积量一定时，改变混凝土含砂率对于弹性模数并没有太大的影响。
- The equivalent elastic modulus was deduced by comprehensive considering deflection and elastic modulus. 通过综合考虑挠度引起弹性模量和弹性伸长引起弹性模量推导出等效弹性模量。
- The elastic moduli Eijlm represents a tensor of the fourth order. 弹性模数Eijlm表示一个四阶张量。
- The effects of fiber distributing orientation and its length on elastic modulus of solidified resin are discussed. 依据复合材料相关理论预测了固化层片及固化零件的机械性能，如弹性模量、强度。
- The elastic modulus of foam core and composite skins and the stiffness of sandwich are analyzed. 分析了复合材料面层的弹性常数、泡沫芯层的模量和夹层结构的刚度;
