您要查找的是不是:
- RECIPROCITY REQUIREMENT AND ZERO GEOMETRICAL TOLERANCE 可逆要求与零形位公差
- zero geometrical tolerance 零形位公差
- Study on Geometrical Tolerance of Mould Manufacture 模具制造中形位误差剖析及对策探讨
- indication of geometrical tolerance 形位公差标注
- Taking into account assembly tolerance and geometric tolerance, with the maximum and minimum method, a parallel degree calculating method for the missile launcher is put forward. 以某型空空导弹四联装发射装置为例,对空间尺寸链的设计计算方法进行了研究。
- General dimensional tolerance and geometric tolerance stipulated in this standard are applicable to weldment, welding assembly parts, and welded construction. 本标准规定的一般尺寸公差和形位公差适用于焊件、焊接组装件和焊接结构。
- The mathematical models of evaluating profile error of any surface take by CMMS are proposed, these methods has been proved fitting for the geometrical tolerances standard by using optimization edited in Turbo C. 介绍了在三坐标测量机上测量和评定面轮廓度误差的数学模型 ,和应用最优化方法用TurboC语言编制的计算机程序 ,经校核验证 ,该算法符合形位公差国家标准的有关规定。
- The mercury dived to ten below zero. 温度突然下降到零下10度。
- A Superficial Coent on the Direction and Position of Geometrical Tolerance Zone 浅谈形位公差带的方向与方位
- Works to achieve a Zero Tolerance for defects. 保持产品缺陷达到零偏差。
- Geometrical tolerance logical choice and accurate label at the products design 产品设计中形位公差的合理选用与正确标注
- Now, men, zero in your guns at that ship. 喂,伙计们,把炮口对准那艘船。
- It was five below zero last night. 昨夜温度是零下五度。
- Based on the national standards on geometric tolerance, the paper analyses the significance of ER (Envelope Requirement), MMR (Maximum Material Requirement) and LMR(Least Material Requirement). 本文根据形位公差国家标准的有关规定,剖析了包容要求、最大实体要求和最小实体要求的含义。
- Geometrical theorems grew out of empirical methods. 几何定理是从经验得出的。
- Prospects of success in the talks were put at zero. 会谈没有成功的希望。
- He has given my suggestion zero thought. 他一点也没有考虑过我的建议。
- The thermometer fell to zero lastnight. 昨夜温度计显示气温下降到零度。
- The thermometer shows ten below zero. 温度计指着零下十度。
- This has gone beyond the gauge of her tolerance. 这已超出她的忍受范围。