您要查找的是不是:
- Measuring Wear Properties of Fluid Lubricants (Falex Method), Method for (05. 液体润滑剂的耐磨损性的测量方法(润滑剂的耐热耐压法)(05。
- wear properties of lubricants 润滑剂的抗磨耗性质
- The friction and wear properties of the sintered samples were analyzed. 对烧结后的样品进行了摩擦磨损性能研究。
- The effect of lubricants on the mechanical properties of WRPC was minimal when their weight fraction was 3%. 当润滑剂的总用量为3%25时,其对WRPC性能的影响较小。
- The mechanics,friction and wear properties of graphite/MoS_2 filled Ekonol/PTFE composites were studied. 采用石墨/二硫化钼填充改性聚苯酯/聚四氟乙烯复合材料,研究了复合材料的力学性能和摩擦磨损性能。
- Vf , fiber orientation, fiber surface treatment, load and velocity have an great effect on friction and wear properties of K3D/EP composites. Vf、纤维取向、纤维表面处理以及载荷和速度对K3D/EP复合材料的摩擦磨损性能有很大影响。
- The friction and wear properties of PTFE and POB filled PTFE composites are studied by using a reciprocating tribometer. 利用往复式摩擦磨损实验机,对PTFE及POB填充PTFE复合材料在不同载荷、不同频率条件下的摩擦磨损性能进行了研究。
- The effects ofload and sliding velocity on the wear properties of the composites were discussed and the wear mechanisms were also inves-tigated. 滑动速度对复合材料的摩擦因数影响较小,但对磨损率影响较大。
- The friction and wear properties of three types of permalloy audio heads were investigated under practical using conditions. 在实际使用条件下,研究了三种坡莫合金录音磁头的摩擦学性能。
- Flake vermiculite has some good effects on the friction and wear properties of friction composites at high temperatures. 蛭石片对其增强的摩擦材料的高温状态下的摩擦与磨损有较好的稳定作用。
- Effect of Fe content on friction and wear properties of Cu-ceramet friction materials[J].Journal of Materials Engineering,2002(8):17-19. Fe含量对Cu基金属陶瓷摩擦材料摩擦磨损性能的影响[J].;材料工程;2002(8):17-19
- The effects of silicon oillubricant on friction and wear properties of mullite-based ceramics were inrestigated in this paper. 硅油润滑条件下,莫来石基陶瓷的磨损机理主要是微观断裂和磨料磨损。
- The frication and wear properties of the single crystal copper wire and Cu-Ag alloy wire prepared by Ohno continuous casting were studied on the modified MS-T3000 wear tester. 在经改制过的MS-T3000摩擦磨损试验机上,对热型连铸技术制备的单晶铜和铜银合金线材进行摩擦磨损对比试验。
- In this paper,the effects of three fillers(barite,vermiculite and porous iron powder) on friction and wear properties of braking friction materials are analyzed. 通过实验,研究了重晶石、蛭石和泡沫铁粉三种常用填料对制动摩擦材料摩擦磨损性能的影响。
- He C X, Ding W M, Shi L P.Friction and wear properties of carbon black filled ultrahigh molecular weight polyethylene composite[J].Tribology,2004, 24 (5): 453-456. [4]何春霞;丁为民;史丽萍.;碳黑填充超高分子量聚乙烯复合材料摩擦磨损性能研究[J]
- He is studying the properties of these particles. 他在研究这些粒子的性质。
- The friction and wear properties of polytetrafluoroethylene(PTFE)reinforced with PTW at different PTW content, temperature, load and sliding speed were investigated. 考察了PTW含量、摩擦温度、载荷和滑行速度对其影响。
- The wear properties of hot-dipped aluminum and complex boroned after hot-dipped aluminum were tested on the MM2 wear tester under laboratory conditions. 用MM2型磨损试验机,在实验室条件下,对热浸渗铝和热渗铝复合渗硼试样进行了耐磨性的对比试验,并采用扫描电镜对磨损后的形貌进行观察分析。
- Measurement of Extreme-Pressure Properties of Lubricating Fluids (Timken Method), Method for (05. 润滑液耐特压特性的测量方法(泰姆肯试验方法)(05。
- Effect of CeO2 on microstructure and sliding wear properties of Cr2O3 ceramic coating with plamsa spraying method[J].Journal of the University of Petroleum,China,2002,26(5):65-67. CeO2对等离子喷涂Cr2O3涂层组织和滑动磨损性能的影响[J].;石油大学学报;2002;26(5):65-67