您要查找的是不是:
- Around the engine cylinder is a water jacket. 围绕着发动机汽缸的是一个水套。
- Reattach cover plate to make an air and water tight seal. 重新固定盖板,并紧密密封防止空气和水通过。
- Slowly open all ball valves to relieve air and water pressure. Loosen bolts on groove coupler and remove groove coupler and cover plate from valve body. 慢慢开启所有球阀,释放空气和水压力。松懈沟槽状联结器上的螺栓,从阀体上拆卸沟槽状联结器和阀盖板。
- Slowly open all ball valves to relieve air and water pressure. Loosen bolts on groove coupler and remove groove couple and cover plate from valve body. 慢慢开启所有球阀,释放空气和水的压力。松开沟槽连接器上的螺栓,从阀体上拆卸沟槽连接器和盖板。
- The injection mould for a duplicator cover plate is designed. 设计了复印机盖板的注塑模具。
- YK:I do all of them. I pick the song titles and also, I usually get involved in the creation of the liner notes and the jacket cover. 这些都是我做的。我选择曲目,也经常参与唱片封套及封套注释的创作。
- A water-cooling system consists of water jacket, water pump, radiator, thermostat, cooling fan, rubber hose, etc. 水冷法系统包括水套,水泵,幅射器,温箱,冷却风扇,橡胶水喉,等.
- Bolted cover plate to protect seal and cylinder from the ingress of debris. 上盖板可防止杂物进入缸筒损坏密封。
- A water-cooling system consists of the engine water jacket, thermostat, water pump, radiator, radiator cap, fan, fan drive belt and neccessary hoses. 一个完整的水冷系统包括机体水套,节温器,水泵,散热器,散热器罩,风扇,风扇驱动皮带和必需的水管。
- A CFD analysis of cooling water jacket on a six-cylinder diesel engine produced now is proceeded by using SWIFT software released by AVL company. 应用AVL公司SWIFI软件,对生产中的6缸柴油机水套进行了CFD分析。
- Disconnect the hose from the bottom cover plate to the relief valve. 断开底部盖板到安全阀上的软管。
- The heat generated by the mixture burned in the engine must be transferred from the iron or aluminum cylinder to the water in the water jacket. 发动机中可燃混合气燃烧所产生的热量必须从铁制或铝制的汽缸中传送到冷却水套里的冷却水中.
- The heat generated by the mixture burned in the engine must be transferred from the iron or aluminum cylinder to the waterin the water jacket. 由混合气燃烧产生的热通过铁质或铝制气缸传至水套中的冷却水中。
- It described the mold tubing, the water guiding casing, the water jacket and the foot roller section for the mold of skelp continuous casting machine. 对管坯连铸机结晶器中结晶器管、水导向套管、水外套钢管和足辊段等部分结构以及对材料的选择、部分参数的确定进行了论述。
- An engine cylinder head gasket leaking between a cylinder and an adjacent water jacket is indicated by coolant foaming or overheating and loss of coolant. 在一个汽缸和相邻的水套之间的引擎汽缸头套环泄漏的标志是冷却液冷却液产生泡沫或者过热,并且冷却液流失。
- Remove the cover plate of the relief valve by removing the four connecting screws. 通过拆卸四个连接螺丝来拆卸安全阀盖板。
- The jacket of WZ 12-1 is a large 8 legs, shallow water jacket, installed in Beibu Bay in the western part of South China Sea where the water depth is 33.67 m and wave is high. 涠洲12-1导管架是一座8腿大型浅水导管架;位于南海西部北部湾;平均水深33.;67m。 风浪较大。
- Because acidified roasting intensity of fluid bed roaster is lower, this paper puts forward a program to modify the water jacket, the cooler, the joint part etc. 由于沸腾焙烧炉酸化焙烧强度较低,提出了改造水套、冷却器、连接等部位。
- If you open the cover plate of your cell phone, you'll see a rectangular LCD on its backside. 把手机的盖板打开来,背面就是一整片长方形的液晶萤幕。
- Fatigue software was adopted to calculate fatigue strength of the water jacket basement submodel before and after modification, and stress test was done to validate the effect. Fatigue软件对改进前后的水套根部子模型进行疲劳强度分析,结合应力测试实验验证改进效果。