您要查找的是不是：
- voltage waveform distortion 电压畸变
- The key is that delay-time difference of dual path and overshoot of voltage transformer can cause composite waveform distortion. 该结构的关键是克服了两通道延迟时间差和变压器过冲产生的合成波形失真。
- The O/P voltage waveform and spectrum.(9). 八、输出端电压之波形与频谱。
- voltage waveform distorted p-q检测法
- The rate of change of the input voltage waveform during a logic transition (low-to-high or high-to-low). 在逻辑转换期间,输入电压信号波形的变化率(由低到高或由高到低)。
- TI ? The rate of change of the input voltage waveform during a logic transition (low-to-high or high-to-low). 在逻辑转换期间，输入电压信号波形的变化率(由低到高或由高到低)。
- To measure the voltage waveform across 2 swinging node (e.g. forward converter rectifier), differential method shall be used, i.e. CH1-CH2. 测量两个变动端之间的电压波形(例如，前置转换整流器)，必须用相减的方法，例如CH1-CH2.
- The product of the transfer function and FFT spectrum of source voltage is further IFFT to the voltage waveform on load of test equipment. 并与拉氏解析法所得之波形比较验证当电路时间常数甚小于电源脉波波宽则仪器负载上之脉波波形受上升与下降时间之影响亦只佔甚小之比率。
- The direct output of D/A is the NRZ(no return zero) sample of the needs voltage waveform. to get the needs voltage waveform must use signal recover circuit. 由D/A转换器直接输出的电压波形是需合成波形的NRZ采样波形，为了得到所需波形，必须采用信号恢复电路。
- The Two Way Automatic Communication System (TWACS) is implemented by modulating the power voltage at preselected zero of the voltage waveform of the distribution network. 摘要双向工频电力通信的基本原理是利用工频电压基波波形过零信息实现信号的调制和解调。
- The influence of the impedence mismatching between the joint section in pulse forming line and the helical line on the voltage waveform of the diode was analyzed. 为消除输出脉冲的前沿上冲和后沿拖尾现象，分析了脉冲形成线中的连接段与螺旋线阻抗的不匹配对输出波形的影响。
- Line-voltage sinusoidal waveform distortion rate 线电压波形正弦性畸变率
- Because the clamp effect of DC voltage source, AC side output the rectangular wave voltage waveform, and it has nothing to do with the load impedance angle. 由于直流电压源的钳位作用,交流侧输出电压波形为矩形波,并且与负载阻抗角无关。
- line scanning waveform distortion 行扫描波形畸变
- power network waveform distortion 电网波形畸变
- It also gives the numerical analysis method using nodal Josephson Junction phase as the basic variable. Then this method is applied in transient simulation of a RSFQ buffer. And the phase and voltage waveform are given out. 文中从约瑟夫逊效应的等效模型出发 ,阐述了 RSFQ电路的基本基理及基于节点约瑟夫逊相位的数值模拟方法 ,并把它用于一个 RSFQ单向缓冲器的瞬态分析 ,给出了其相位和电压波形
- The simulation results show low THD of output voltage waveform and the system achieves good dynamic and static characteristic.This control schemes can satisfy the controlling require of inverter. 从大量的仿真结果中可以看出输出电压波形具有较低的总谐波畸变率(THD),同时还获得了良好的稳态和动态特性。
- For obtaining practical output voltage waveform,the optimized strategy of widening a couple of switch angles is presented based on the specific requirement of on-off time of switching device. 为了得到实际输出电压波形,根据开关器件通断时间的具体要求,提出了展宽开关角对的优化策略。
- The simulation and experiment results show that repetitive control strategy can ensure the output voltage waveform keep the sinusoidal shape well even if the inverter is with the rectifier-type loads. 通过仿真与实验分别验证了当逆变电源带整流性负载时，采用重复控制策略能够保证输出电压波形保持高稳态精度。
- Finally the waveform distortions of these springs are calculated, and the selection criteria of spring parameters in designing ultra-low frequency standard vibrator are provided. 最后计算了不同组合下弹簧的波形失真度，为设计超低频标准振动台波形失真度最小的支承弹簧提供了选择依据。
