您要查找的是不是:
- VASP Virtual Analog Switching Point 虚拟模拟交换点
- virtual analog switching point 虚模拟交换点
- virtual analog switching points 拟实模拟交换点
- VASP? Virtual Analogue Switching Point? 虚拟相似体切换点?
- Pulse Width Decoder-A Flxxible Application of Integrated Analog Switch CMOS. CMOS集成模拟开关的变通应用-脉宽解码器。
- The new DG636 can be used as a dual SPDT analog switch or dual 2:1 multiplexer. 新型 DG636可用作双路 SPDT 模拟开关或双路 2:1 多路复用器。
- VSP? Virtual Switching Point? 虚拟交换点?
- Adjusting screws are used to set the switching point whilst under pressure. 调节螺丝用来确定压力的开关点。
- Subcircuits of control input,level translation,analog switch transistor and static protection are described in detail. 其内部电路设计有控制输入级、电平转换级、高速模拟开关管及静电保护电路。
- Minimum/maximum number of switch points. 开关点的最小/最大数量。
- The weight electric current network overcomed disadvantage of analog switch of breakover resistance and pressure drop in the resistance network. 权电流网络用于克服电阻网络D/A转换器中模拟开关的导通电阻和导通压降。
- VASP Virtual Analogue Switching Point 虚拟相似体切换点
- virtual analogue switching point 虚拟模拟交换点
- Hardware design includes circuits of signal amplification of digital potentiometer, analog switch, A/D conversion, wave conversion, single-chip and peripheral equipment. 硬件设计包括含数字电位器的信号放大、模拟开关及A/D转换、波形变换、单片机及其外围等电路。
- A novel phase synchronously demodulating circuit was introduced in this paper, in which digital controlled analog switch and high power amplifier were adopted. 摘要介绍了一种采用数控模拟开关和大功率运放的角度位置信号同步相敏解调电路。
- A third signal level is thus now available in addition to one programmable switching point and a temperature indication. 从而得到了除可编程开关点和温度指示信号之外的第三级信号。
- The pressure difference determined electronically from the signals of the two sensors is used to control the switching point. 两个压力传感器传出的电子信号表示压力的差别并控制开关点。
- Our products include power management circuits, interface circuits, power supplies, analog switches, ESD protection IC, and EMI filters. 公司产品包括电源管理电路、接口电路、模拟开关、静电保护器、电滋干扰滤波器。
- The three devices are identical except for magnetic switch points. 这三种器件除了磁性开关点以外,其他都是一样的。
- Minimum holding pressure: based on the correct switch point, the pressure when the parts start to be empty. 最低保压压力:在准确的转压点基础上,给予一定的保压压力,当产品刚出现充模不足时的保压压力。