您要查找的是不是：
- variable swirl intake manifold 可调涡流进气道
- variable swirl intake manifolds 可变涡流进气管
- This thesis mainly carries on research of three dimensional surface reconstruction of variable intake manifold and air fluid simul. 可变式进气歧管能提高进气效率,是发动机低转速时能提高缸内负压的可变机构。
- Remove intake manifold, yoke retainer and aligning yokes. 拆下进气歧管、叉臂轭护圈，并对正叉臂轭。
- Direct gasoline injection and hydrogen intake manifold supply. 直喷式汽油和氢气进气歧管供应。
- The principle of electronically controlled variable intake manifold length of vehicle engine is introduced in this paper. The application of this system to Audi V8(2. 8L) engine and Opel Astra(1. 8L)engine are made. 本文介绍车用发动机可变进气管长度电子控制原理;并举出了在奥迪VS(2.;8升)发动机、欧宝Astra(1
- When there is vacuum in the intake manifold, the vacuum holds the diaphragm up. 当进气歧管有真空存在时，真空便向上吸引膜片。
- The main difference is how they move air to the intake manifold of the engine. 这三种形式主要的不同在于它们把空气引入吸气导管的方式。
- This subport-type variable swirl system is possisle to give all kinds of optimum swirl in different operating ranges of diesel engine. 副进气道可变进气涡流机构可满足发动机在各种工况下的进气涡流强度控制需要。
- The effect of variable swirl on the fuel consumption of SI engine when TEFI (Twice Electronic Fuel Injection) was adopted to lean burn combustion was studied. 主要研究了火花点燃式发动机采用二次喷油技术实现稀薄燃烧时,可变涡流对燃油经济性的影响情况。
- The pudding results from the failure of all the fuel to vaporize and from the sorting effect of the intake manifold. 积洼是全部燃料蒸发得不充分和进气歧管类似影响的结果。
- If the engine backfires, the sudden pressure in the intake manifold forces the valve back. 如果发动机回火，进气歧管骤增的压力就迫使阀门向后移动。
- Install the intake manifold (refer to Group 11, Exhaust System and Intake Manifold). 安装进气歧管（见单元11-排气系统和进气歧管）。
- Remove the intake manifold (refer to Group 11, Exhaust System and Intake Manifold). 拆下进气歧管（见单元11-排气系统和进气歧管）。
- On a typical in-line six-cylinder engine the carburetor is located on the intake manifold between cylinder 3 and 4. 在标准的六缸直列式发动机上，化油器被设置在进气歧管上3号和4号缸之间。
- This device, called the manifold heat-control valve, is built into the exhaust and intake manifold. 这种装置称为“歧管热控制阀”，它拼装在排气与进气歧管中。
- The piston moves up and down in the piston chamber primarily in response to changes in intake manifold vacuum. 活塞主要因进气歧管真空度的变化而在活塞腔内上下移动。
- When the engine is shut off, the intake manifold cools and a slight vacuum forms as a result. 这是因为当发动机熄火时，进气歧管冷却而产生轻微的真空。
- Fault Description(reason): High voltage detected at intake manifold pressure sensor signal pin. 故障描述（原因）：检测到进气歧管压力传感器信号电压值高。
- Intercooler installed in front of the radiator, intake manifold pipe joint moved to shorten path for intercooler hoses. Added oil flow to engine. 水箱前安装冷热气自动调节器,水管及入口改装,增加引擎喷油量。
