您要查找的是不是:
- Please check whether the open pressure of safety valve is in good condition. 请检查安全阀的开启压力是否正常。
- Opening Pressure of Fuel Injector: 15,000–15,8kPa (2175–2291 psi). 燃油喷射器打开压力: 15;000–15;8kPa (2175–2291 psi).
- One, why is a small two-seater valve opening oscillation work easier? 为什么双座阀小开度工作时容易振荡?
- The vacuum valve opens to admit air. 真空阀开启以补充空气。
- The failure of valve opening sensor would cause valve management of DEH system working confusedly,and result in large scale change of turbine power in the case of governing stage pressure loop idle. DEH系统中阀位传感器的故障会给阀门管理带来混乱,特别在调节级压力回路未投入的情况下会引起汽机功率的较大变化。
- When the coid is powered the valve opens (t< 1s). 当切断电流时,阀门迅速关闭。
- By applying black box theory inlet pressure, inlet subcooling, outlet pressure and valve opening are selected as influence factors to flow coefficient of electronic expansion valve (EEV). 根据黑箱理论提出将阀前压力、阀前过冷度、阀后压力和膨胀阀流通面积作为膨胀阀流量系数的影响参数。
- A type of engine fuel injector of 12-cylinder was set up to form five kinds of fault,they are nozzle blockage,needle valve clip,spring break,very low and very high pressure of needle valve open. 某12缸发动机喷油器上设置的5种故障分别是喷孔堵塞、针阀卡滞、弹簧断裂、针阀开启压力过低和针阀开启压力过高。
- As DME is easy to atomize and evaporate, the nozzle opening pressure was lowered. 试验结果表明,该燃料的喷射与燃烧过程明显不同于柴油。
- So the exhaust valve opens before BDC and closes after TDC. 因此排气门在下止点之前打开,在上止点之后关闭。
- The penetration and flabelliform angle increase as the opening pressure increases. 随著启喷压力的增加,喷雾贯穿距和扇形角也相应增大;
- If the pressure builds up excessively, the pressure valve opens to relieve the pressure. 如果油箱内压力过高,则压力阀开启,以降低压力。
- REPAIR THE OPEN PRESSURE SWITCH SENSE CKT BETWEEN SOLENOID PACK AND TCM CONNECTORS. 维修在电磁组和TCM接头间断开的压力开关感知电路。
- The direction of fuel spray after impingement and opening pressure of nozzle were important factors to influence fuel and air mixing and burning process. 另外撞击反弹方向和喷油压力等也是影响混合气形成和燃烧的重要因素。
- Regeneration opportunity and regeneration valve opening of DPF are controlled by 80C196KB single chip microprocessor. 采用80C196KB控制柴油机微粒过滤器再生时机和再生调节阀开度。
- The valve opens for tank discharge when tank head pressure is greater than valve inlet pressure. 当容器水头压力大于阀门进口压力时,阀门开启进行容器排放。
- Locate percentage of valve opening on the bottom scale of Flow Characteristic Curve (Fig. 6). 从流量特性曲线(图6)的底部刻度找出阀门开启度百分比。
- If closed port pressure exceeds open pressure ,ball may be forced off of the seat ring whhich could allow mixing from all ports. 如果关闭端口压力超过开启端口压力,球可能会被压出能够混合所有端口流体的阀座环。
- For snap action, the main valve opens rapidly at set pressure and achieves rated relieving capacity at relieving pressure. 对于快动式先导器,主阀门在达到设定压力时快速打开并且在泄放压力时达到额定排放量。
- For modulating action, the main vent valve opens gradually with increasing pressure and achieves rated relieving capacity at relieving pressure. 对于调制式先导器,主阀门将随压力增加而逐渐打开,在泄放压力时达到额定排放量。