您要查找的是不是:
- Seal Pressure of Hydraulically Expanded Tube to Tube Sheet Joints 液压胀接接头的密封压力
- Research on tube to tube sheet welding process of condenser made of duplex stainless steel 双相不锈钢冷凝器换热管与管板焊接工艺
- Research on Leakage of Strength Expanded Tube to Tube Sheet joints of Heat Exchanger 换热器强度胀接接头的泄漏和防止措施
- tube to tube sheet 管与管板
- tube to tube sheet welding 管与管板焊接
- Suck on the tube to draw up the water. 用管子把水吸上来。
- Taking, internal bore welding for tube to tube plate on the low pressure reaction water condenser for example, the procedure test and products welding is decribed. 以低压反应水冷凝器管子管板内孔焊为例,叙述了不锈钢管子与管板内孔焊接的工艺试验和产品焊接。
- He silently applied the tube to his lips. 他默默地把烟管递到嘴里。
- Heat the glass tube to the point that it can bend. 将玻璃管加热,以能弯曲为度。
- Tube to tubesheet joint shall be rolled. 管子与管板的接头应是滚压接合?
- TYP side of 10”´4”rect tube to plate. 矩形管多处相同的边与板相接。
- TUBE TO TUBE ARC WELDING MACHINE SERIES 管子对接自动弧焊机系列
- The culprit is the inability of the Eustachian tube to open. 遇到这样的问题是由于咽鼓管不能打通引起的。
- Remove sealer from axle tube to housing junction, if necessary. 如有必要,拆卸轴管和轴管接头间的密封件。
- Connect drainage tubing to end of catheter. 将引流管与导尿管连接。
- Grind purely the hole of the tube and measure the distance between the upper and lower tube sheet. 将需更换管子的管孔磨清理干净,测量上下管板间的实际距离。
- The steam leakage was occurred on the welding zone of the tube sheet of the austenitic stainless steel heat exchanger. 摘要在奥氏体不锈钢制再沸器的上管板与壳程筒体焊接的管板一侧发生蒸气泄漏。
- It is suitable to tube amp. but it is also too expensive la! 终于领略到帮助别人原来是一件很快乐的事情,明白施比受更为有福的道理!
- The design experience of fixed tube sheet (not as flange) is summarized from analyzing & comparing the results based on GB151 & TEMA. 针对工程实例;对采用SW6-1998 V3.;0程序(基于(GB151-1999)计算方法与TEMA标准的计 算方法所得结果进行比较分析;总结出管壳式换热器不兼做法兰管板的设计经验。
- The steam generator of FCC unit in Jinzhou Petrochemical Company is head-floating steam generator and its tube sheet cracked after it was put into use more than a year. 锦州石化公司催化裂化装置采用的浮头式油浆蒸汽发生器,投用一年多(在其设计寿命之内)就发生失效。