您要查找的是不是：
- REMOVE THE DRAIN PLUG AND DRAIN THE OIL. 旋开排油栓排掉机油。
- REMOVE THE OIL DRAIN PLUG, AND DRAIN THE OIL. 取出排油栓
- Tighten the oil, drain plug and, fill the oil to the, oil filler neck. 拧紧排油栓,注入机油至机油过滤器颈部。
- Separate the rear universal joint from the transfer case yoke. 从传动箱轴轭上拆下后万向节。
- Remove drain plug from bulkhead fitting and install valve assembly. Hand tighten. 从堵头连接件上拆卸排泄塞,并安装阀门总成。用手紧固。
- Check all drain plugs are fitted. 检查放泄塞是否已装好。
- If the level is correct, fluid should just trickle, or drip out of, the centre of the drain plug. 如果油量正确，你只会见到波箱油慢慢滴或者流出黎。
- Align mark on the rear link yoke and universal joint to the mark on the transfer case yoke. 将后连接轴轭和万向节上的标志与传动箱轴轭上的标志对准。
- Shift the transmission and transfer case, if necessary, into the Neutral position. 视需要将变速箱和传动箱换至空档位置。
- The motor of Vibroseis drives over 5 - 6 hydraulic pumps by transfer case so that its hydraulic system is very complex. 可控震源的发动机通过分动箱驱动了五、六个以上的液压泵,因此,可控震源的液压系统较复杂。
- This picture was taken after the oil change had been completed.But I really wanted to show how we loosened the drain plug with the tool.See the double-headed wrench, one open and one closed. 这张照片是换好机油后所拍的;因为我实在很想告诉大家我是使用何种工具将洩油螺丝松开的;瞧这有双头的扳手;一头有开口;一头是圆的中间有孔的.
- If vehicle is equipped with automatic transmission install shifter interlock cablRefer to Group 21 Transmission and Transfer Case for procedure. 如果车辆装备了自动变速箱，安装变档互锁电缆。有关程序请参阅单元21之变速箱和加力箱。
- Transfer case,different size Hydrant;Compreser body precisicen casting; Duefile casting; Wear high-chromium iron casting and heating-proof casting. 变速箱、消防栓壳体系列；制冷压缩机精密铸件；球铁铸件；耐磨高铬铸铁件及耐热件。
- The competent DSAD shall deal with the transferred case in good time. 有管辖权的药品监督管理部门对移送的案件应当及时查处。
- CYLINDER BLOCK COOLANT DRAIN PLUG 汽缸体冷却剂放油旋塞
- 3) Transfer case shift linkage binding. 动力分导齿轮箱排挡连杆结合。
- TRANSFER CASE SHIFT LEVER POSITION 辅助变速箱排挡位置
- Card front, rear drive the transfer case 供应驱动分动箱
- Transfer case castings and components 分动器铸件和零件
- Drain and transfer to a large bowl. 沥干并放入一个大碗中。
