您要查找的是不是:
- Measurement of the cooling fan flow of the locomotive traction motor using total pressure method 全压法测量动力车牵引电机冷却风机风量
- total pressure method [化] 总压法
- Ultimate pressure is measured as total pressure. 最后压力是全程压力测量值。
- The ways to stop bleeding include direct pressure method and indirect pressure method. 止血方法可分为直接压法及间接压法。
- When Ma(subscript e)=0.45 the relative suction flow rate equals 0.043, the total pressure recovery increases by 2.6%. 在出口马赫数为0.;45,相对抽吸量为0
- Thermal pressure method is part of resin inlaying, for which thermosetting resin is widely used. 热压镶嵌法属于树脂镶嵌法,其中,采用热固性树脂又是非常普遍的。
- Cavity length depth ratio strongly influences flow field、total pressure recovery、drag coefficient. 凹腔长深比对流场特性、总压恢复、燃烧室阻力影响显著。
- Tension method also can distinguish permeability of different concrete, but it has discreteness compared with water pressure method. 通过研究张力法下水在混凝土中的渗透发现:水在张力法下更容易渗透,张力法下的渗透系数比水压法下大一个数量级。
- Effects of blade negative bowing on secondary flow, total pressure loss and outlet flow angle were analyzed quantitatively, mechanism of the effects was discussed as well. 定量地分析了叶片反弯曲对叶栅出口二次流、总压损失和气流角的影响,并探讨了叶片反弯曲作用的机理。
- Breakthrough pressure method was presented in order to accurately determine the plugging position of water shutoff agent in oil reservoir. 为了能更准确地预测堵剂在油藏中的封堵位置,提出了堵剂突破压力法。
- The experimental data showed that the total pressure drop of the cross-flow RPB was influenced by rotating speed, gas flow rate and liquid flow rate. 实验表明错流旋转填料床的气相总压降与气体流量、旋转床转速、液体流量有关。
- The results show that total pressure recovery coefficient of this type inlet is increased in every yawed flight,and are less related to the yaw angle. 研究结果表明,这类进气道在各种侧滑状态下总压恢复系数较高,且与侧滑角的关系不大。
- The dynamic surface tension of aqueous solution of alkyl glucoside(APG) C_(8/10)G_(1.31) and C_(12/14)G_(1.43) was studied by using maximum bubble pressure method. 采用最大泡压法研究了表面活性剂烷基聚葡糖苷(APG或CiGj)C8/10G1.;31和C12/14G1
- The flow field characteristics and the total pressure recovery performance for different diffuser configurations were analyzed. 对不同构型扩压器的流场特点、总压恢复性能进行了分析;
- Velocity circulations at the trailing edges of each blade-row are optimized for overall maximization of total pressure ratio and isentropic efficiency. 优化目标为总压比和绝热效率最大,决策变量为转子和静子叶排尾缘速度环量。
- The experiments result shows: the model Z decreases the mean value and peak value of PRMS while upsream total pressure varies from 0.3 atm to 0.7 atm. 实验结果表明:开孔与中绊线组合方案对进口压力从0.;3到0
- The influences of the inlet angle and inlet total pressure of fluid on the temperature of electrode surface and nozzle exit fluid was analyzed. 分析了空气进口气流角、进口总压和等离子化学反应对电极壁面温度及喷嘴出口气流温度的影响。
- Based on static pressurizing method,the leakage and degassing rate of a dewar of 210 L was measured. 运用静态升压法对国内某厂家生产的210L杜瓦的漏放气速率进行测量;绘制了夹层压力随时间的变化曲线;测得总漏放气速率为2.;0×10-8Pa
- Presents the balance valve make-up water pressurization method used in substation reformation. 摘要介绍了在换热站改造中采用的平衡阀补水定压方式。
- A multiobjective optimization for a two-stage axial-flow compressor design was performed for maximization of the overall adiabatic efficiency and the total pressure ratio. 针对一台两级轴流压气机,选定优化设计的目标是最大的总压比和最高的总绝热效率。