您要查找的是不是：
- Discussion on atmospheric capacity calculations and total load control in regional environmental impact assessments 区域环评中大气环境容量计算及总量控制探讨
- total load control 总量控制
- This is a load control forms of code. 这是一个控制窗体加载的代码.;-
- Total load was then obtained by graphical or numerical integration. 然后，通过图解积分或数值积分可求得总载荷。
- Total loading control 总量控制
- Line |1: All controls must precede menus; cannot load control |2. 行 |1：所有的控件都必须优先于菜单；无法加载控件 |2 。
- It has been proved, the bed material load, wash load and total load follow the same rule of carrying capacity. 证实了床沙质、冲泻质与全沙具有统一的挟沙能力。
- And furthermore, the self-organized criticality of the power system is revaled fromteh viewpoint of the network capability and total load demanding. 并从系统总负荷需求和网络传输容量揭示电力系统的自组织临界性。
- A control system includes an electrical load control device responsive to radiant energy and a transmitter. 一种控制系统包括一响应于辐射能的电力负载控制器件及一发射机。
- Elster Metering's products include electricity, water and energy meters, metering systems, and load control solutions. 埃尔斯特集团公司产品包括电表、水表、能量表、表计系统和负荷控制。
- The load control device resides on a digital communications link and receives infrared commands via a lightpipe. 该负载控制设备驻留在数字通信链路上，并且经由灯管接收红外命令。
- Highest performance is observed at a total loading of 25 wr% MoP in HDN of Q. 研究表明MoP的负载量为25wt%25时催化剂具有最佳的HDN活性。
- Simulation results indicate that the model has better ability to represent the locomotive total load characteristics, which can be used in power system simulation and analyses. 通过仿真结果分析，表明此仿真模型对电力机车整车负荷特性有较好的描述能力，适合用于电力系统的相关仿真和分析中。
- Electricity metering equipment (a. C.) - General requirements, tests and test conditions - Part 21: Tariff and load control equipment. 电量测量设备(交流)。一般要求、试验和试验条件。第21部分:资费和负荷控制设备。
- All of the above will be a basis for the studies of flow load control, power supply recovery and damage loss mitigation of power system after earthquake. 该工作可为震后电力系统负荷快速调整、震区供电系统较快恢复电力供应，减少供电工程系统的损失提供理论分析依据。
- H.-T. Yang and K.-Y. Huang, “Direct load control using fuzzy dynamic programming”, IEE Proc.-Gener. Transm. Distrib., Vol. 146, No. 3, May 1999. 张明吉，“冷气机之节约电力需量控制法则”，电机月刊，第九卷，第七期，页244-249，七月，1999。
- H.-T.Yang and K.-Y.Huang, “Direct load control using fuzzy dynamic programming”, IEEE Proc.-Gener.Transm.Distrib., Vol. 146, No. 3, May 1999. 杨正光，陈嘉裕，“直接控制负载管理策略应用”，台电工程月刊，第584期，页82-96，民国86年4月。
- Load Demand is a paralleling system operating mode in which the system monitors the total kW output of the generator sets, and controls the number of operating sets as a function of the total load on the system. 负载需求是并联系统的一种运行模式，系统监控发电机组总的输出功率，根据系统总负载量决定运行机组的数量。
- The paper analyzes the problems about power sources input point in load control unit and the uncompatibility of facilities of different factories. 分析了目前负荷管理系统存在的负控终端电源引入点问题、不同厂家之间的设备不能相互兼容问题等，提出了加以改进的设想。
- The suggestions and assumptions am given to perfect load control installation hardwire structure and choose communication mode. 在负控装置硬件结构的改进及通信方式的选择上，提出了一些建议和设想。
