您要查找的是不是：
- A Study on the Thermal Cycling Fatigue Behavior of Zirconia Toughening Mullite Ceramics 氧化锆增韧莫来石陶瓷热循环疲劳行为研究
- thermal cycling fatigue 热循环疲劳
- Pb-free solder;BGA;thermal cycling;dynamic fatigue tests;electrical analysis. 关键词:无铅焊锡;球格阵列构装;冷热循环试验;动态疲劳试验;电性分析
- As a result of repeated thermal cycling, fatigue cracks developed in the solder interconnects. 随着热循环周数的增加，焊点中出现疲劳裂纹。
- The thermal shock and thermal fatigue behaviors as well as their controlling factors of ZrO 2-Ni functionally graded material (FGM) were studied by thermal shock and thermal cycling tests. 通过抗热震参数分析和热循环试验研究了ZrO2 -Ni功能梯度材料 (FGM )的热冲击与热疲劳行为及其影响因素 .
- A low cycle fatigue (LCF) testing on 16MnL sheet steel is reported. 本文工作对汽车大梁所用的16MnL薄板钢材进行了低周疲劳试验研究。
- Thermal expand coefficient of polyimide films at each temperature was measured in the process of thermal cycling. 摘要测量了聚酰亚胺薄膜在冷热循环过程中各温度点的热膨胀系数。
- Heating system guarantees the drying of glass because of adopting thermal cycling wind. 采用风机的热循环风，并有加热系统保证了玻璃的干燥度。
- A multi-system lumped heat capacity analysis has been adopted to simulate the thermal cycling of the micro chamber PCR chip. 本文采用多体系集总热容法分析了微腔型PCR芯片的热循环过程,研究了芯片的温度变化规律,并提出了芯片功耗的预测方法。
- Low cycle fatigue properties are affected adverselyby abusive grinding. 过量磨削对低循环疲劳性起着有害的作用。
- Based on the thermojunction assignment test, actual thermal cycling curve of welded seam heat-affected zone is obtained. 在热电偶标定测试的基础上，通过实验获得了焊缝热影响区的实际热循环曲线。
- Thermal cycling absorption process(TCAP) in a full reflux mode was studied at different feeding ratios,feeding places and heating/cooling temperatures. 分别在不同进料比、进料位置、加热/冷却温度的条件下,对TCAP工艺的全回流模式进行了实验。
- Thermal cycling absorption process(TCAP),a semi-continuous hydrogen isotope separation process,is of many unique advantages. 对热循环吸附法(TCAP)全回流模式和生产模式下的氕-氘分离实验进行了研究。
- Threaded seat rings for valves in services with high velocity (turbulent) flow or thermal cycling should be lock welded to the body to avoid loosening. Please specify. 如果阀门用在高速流体(湍流)或热循环应用环境中,则螺纹阀座环应该锁焊到阀体上,避免松落。请在订购时加以指定说明。
- The initial requirements involved the belief that the presence of a duplex or "necklace" structure was intolerable from a low cycle fatigue aspect. 最初有人认为从低周疲劳性能的角度来说双层或“项链”组织是绝对不行的。
- During thermal cycling, no obvious change of EM was observed but areversible change of EDP was, which is shown to correspond to reversible DO_3-M18R transformation. 在热循环中,衍衬像不发生明显改变,但观察到可逆的电子衍射图变化,分析表明这是可逆的DO_3?M18R型相变。
- Elastoplastic finite element analysis and low cycle fatigue life prediction of an engine combustor case were completed. 对某发动机燃烧室外套进行了弹塑性有限元分析和低循环疲劳寿命预测。
- The results show that low cycle fatigue life is reduced and cyclic stress is raised by torsional prestrain raising. 结果表明，扭转预应变降低低周疲劳寿命，循环应力随扭转预应变的增大而增大。
- However, the solder joint reliability under thermal cycling conditions becomes a critical problem when mounting the WLP onto a PCB when the underfill layer has been eliminated. 然由于晶圆级构装不填注底胶，因此当晶圆级构装于组装PCB基板后承受热循环负载时，焊锡接点可靠度已成为构装结构主要可靠度问题之一。
- Finally, the future directions in the research of multiaxial low cycle fatigue are suggested. 并建议今后多轴低周疲劳课题的研究方向。
