您要查找的是不是：
- The resistor is first measured with test voltage V1, giving R1. 首先在测试电压V1之下测量电阻器，得到R1。
- Multifunction of testing voltage value, current value, RF value and transient current strength. 多用途测试电压值,电流值,射频值及瞬变电流强度等。
- Test Voltage of Loading at high temperature test is 1.5 Time of the rated voltage. 高温负载试验电压为额定电压的1.;5倍。
- De-energize Ch. 42, then open Ch. 1 and close Ch. 2 to apply the test voltage to terminal 3. 释放通道42，然后开路通道1，并闭合通道2，向端子3上施加测试电压。
- With this method, the user enters the test voltage, measurement time and the number of iterations. 使用这个方法，用户输入测试电压、测量时间和重复次数。
- The voltage rating of these resistors must be at least equal to the test voltage. 这些电阻器的电压额定值必须至少等于测试电压。
- Next, it is measured with test voltage V2 (where V2is greater than V1), giving R2. 接着在测试电压V2之下（V2大于V1）测量电阻器，得到R2。
- Note the exponential decay in the current using both a positive and a negative test voltage. 注意在使用正、负测试电压时电流的指数衰减情况。
- This application employs a Model 6517A Electrometer, which can supply the test voltage and measure the residual voltage. 这种应用情况使用了一台6517A型静电计，它能够供给测试电压并测量剩余电压。
- The test voltage shall be the nominal system voltage corresponding to the ballast input voltage rating, as specified in Table 16.3.3.1. 如表16.;3
- Spark test voltage values given by the potential difference between the test electrode and the conductor of the core or cable under test shall be specified in the cable standard. 火花试验时,电极与被测试电线或电缆之间的电位差的值在电线标准中有明确规定。
- The Model 6524 High Resistance Software enables the user to view the actual current waveform that results from the applied alternating polarity test voltage. 6524型高阻测试软件使用户能够观察由施加变换极性测试电压所产生的实际电流波形。
- In the ESD test on the CAN bus body system and equipments of bus, it appeared that some indicator lights worked abnormally when test voltage is advanced. 在对汽车CAN总线控制系统进行防静电测试中，出现了测试电压调高后部分指示灯工作异常的情况。
- Measurement uncertainties which cased by LED orientation uncertainty,spectrum mismatch and LED fast test voltage pulse in the PLF on-line test are analyzed. 分析了LED定位不确定度,探头光谱失配和LED快速测试上电脉冲三方面对LED在线测试中部分光通量(PLF)测量不确定度的影响,并对光强分布为叶子形的LED进行了计算与实验。
- One set of switches is used to apply the test voltage to each capacitor in turn; a second set of switches connects each capacitor to the picoammeter after a suitable soak period. 一套开关用来轮流向每一个电容器施加测试电压，另一套开关在适当的浸润时间之后将每个电容器连接到皮安计。
- A simple test will show if this is real gold. 简单的试验就能证明这是否是真金。
- A motor that is be directly coupled to a fan-blade or blower-wheel load is to be operated at the applicable test voltage and under no-fan,no-load conditions with the shaft running free. 直接与风机叶片或鼓风机叶轮相连的电机将在合适的测试电压及无风叶无负载轴自由运转的条件下工作.
- Abstract： The reason for not suitable for calculation of voltage index are reviewed only based on two test voltages and test durations specified in the products standards. 摘 要： 阐述了仅仅依据产品标准中规定的两个试验电压及其试验时间，不宜计算电压指数的理由。
- Pupils who pass the test will be promoted to the next higher grade. 小学生只要考试及格就会升到高年级。
- We are testing the efficacy of a new drug. 我们正在测试新药的功效。
- 今日热词
-
- 深远海浮式风电平台 - deep-sea floating wind power platform
-
- 京雄高速公路 - Beijing-Xiongan expressway
-
- 农业及相关产业增加值 - the added value of agriculture and related industries
