您要查找的是不是：
- supply voltage curve 供电电压曲线
- Ohmic resistance measured between the supply voltage connections. 供电电路中测得的电阻(欧姆)。
- Features: Low VCE(sat),High performance at low supply voltage. 特点：饱和压降低,功率高和电压小。
- R1 charges up the negative side of C1 to the supply voltage, VDD. R1将C1的负向充电到供电电压VDD。
- This capacitance is discharged when the supply voltage is switched on. 为什么电源电压接通时电容是放电?
- This equates to reclosing with twice the supply voltage on the motor. 这等于再合闸电机上有两倍的电源电压。
- Two wires for the supply voltage and one for the receiver's R/C sum signal. 通常没有被引出，所以我们要打开接收机找到其中的那个焊点，将它引出。
- This paper presents a novel current source which is insensitive to supply voltage. 摘要这篇论文提出了一个和电源电压变动无关的新式电流源。
- Because the power supply rejection of most ADCs is fairly high, drifts in the power supply voltage do not adversely affect the measurement. 由于多数模数转换器的电源滤波是相当高,电源电压有害地偏差不影响这次测量。
- For mains-independent service in the field, the sensor can operate with a supply voltage of 6V. 传感器独立于主电源工作,可以在6伏的供电电压下运行。
- Power Supply Rejection: The ratio of the change in input offset voltage to change in power supply voltage producing it. 电源抑制比,输入失调电压变化量与引起该变化的电源电压变化量之比。
- The Voltage Selector Setting should be checked to see that it conforms to the local AC supply voltage. 必须查看本机交流电压选择器之预调状态是否符合本地交流电压。
- YOU MUST ENSURE THE BATTERY AND / OR POWER SUPPLY VOLTAGE DOES NOT EXCEED THE MAXIMUM SPECIFIED FOR YOUR SERVOS. 您必须保证电池和/ 或电源电压不超出最大值被指定为您的伺服机。
- moisture and flash over voltage curve 湿度对跳火电压特性曲线
- The power supply voltage may be controlled by replacing D1, D2, R1 and R2 with a variable voltage reference. 将D1、D2、R1和R2换成一个可变参考电压源，本电路就变成了一个可控电源。
- The reference voltage, VREF, is applied externally and can be set up to the supply voltage, VDD. 基准电压（VREF）由外部提供，最高可以设置为电源电压VDD。
- Voltage generated by the motor at the instant of reclose may be equal to the supply voltage but exactly out of phase. 再合闸瞬间电机产生的电压可与电源电压相等但正好失相。
- However if the supply voltage or ambient temperature is low the machine still reduces input power at this preset time. 然而如果电压或环境温度低，机器仍要在这时减少能量输入，就会导致烘焙时间长和“烤豆”。
- Supply voltage (effective value, frequency and waveform) for which the technical specifications of the force transducer apply. 力传感器所使用的技术说明中所规定的供电电压(有效值、频率、波形)
- The required supply voltage shall be within the scope of changes to meet the standards in section 5.3 Of the basic functional requirements. 在规定电源电压变化范围内均应满足本标准第5.;3条的基本功能要求。
