您要查找的是不是:
- fast expending of supercritical liquid flow 超临界流体溶液快速膨胀法
- supercritical liquid flow 超临界流体
- Difference of pressure makes a liquid flow through a siphon. 压力差使得液体通过虹吸管。
- Wenzhou Yongchen Tube For Liquid Flow Co., Ltd. 温州永晨流体管道有限公司。
- Concept, theory and characteristics of supercritical liquid, reaction kinetics and reaction selectivity under supercritical liquid. 摘要介绍了超临界流体的概念、原理和特点,及在超临界下反应动力学和反应选择性。
- LIQUID FLOW MEASUREMENT IN OPEN CHANNELS. PARSHALL AND SANIIRI FLUMES. 明渠液流测量。
- A liquid flows freely and has no fixed shape. 液体能自由流动,无固定形态。
- As of the flow of a liquid flowing,such as blood from a wound. 关于能流动的液体的流动,关于从伤口流出的鲜血。
- There is liquid flowing on the surface of Titan. 土卫六的表面有液体流动。
- Therefore, the general Reynolds equation is derived based on continually of liquid flow. 由此根据液流连续性推导出广义雷诺方程。
- The selectivity and activity of enzyme in the reaction media, especially in ionic liquids and supercritical liquids was reviewed in the paper. 文章以溶剂分类,探讨溶剂,特别是引入新的反应介质-离子液体和超临界流体对酶催化活性和选择性的影响。
- Main factors affecting on liquid holdup are pressures, pipeline diameters and gas &liquid flow rate. 影响持液率的因素主要有压力、管径、气液相流量等。
- It was shown that the reasonably modified DJ trays and Linde sieve trays have a more uniform liquid flow. 认为由于DJ塔板与导向筛板采用了合理的改进措施,使得液流分布更均匀。
- When the liquid flow rate is high, the addition of gas into the flow would have less influence on the variation of WSS. 在高液流速度下,加入气泡后壁面切应力波动幅度的变化较小。
- The severe slugging can occur only when both gas and liquid flow rates are relatively low. 严重段塞流的发生严格受到气、液相流量大小的限制,只有在气、液两相流量都较小的工况下,严重段塞流才会发生;
- MEASUREMENT OF LIQUID FLOW IN OPEN CHANNELS. TRACER DILUTION METHODS FOR THE MEASUREMENT OF STEADY FLOW. PART 4: FLUORESCENT TRACERS. 明渠流量的测量。测量稳定流速用的示踪稀释法。第4部分:荧光示踪剂。
- The experimental data showed that the total pressure drop of the cross-flow RPB was influenced by rotating speed, gas flow rate and liquid flow rate. 实验表明错流旋转填料床的气相总压降与气体流量、旋转床转速、液体流量有关。
- It was found that gas injection at riser base could eliminate the severe slugging and stabilize the gas and liquid flow rates at the riser outlet. 实验结果表明,采用上升管下部注气的方法可以消除严重段塞流现象,实现管道出口气液的稳定流动,减小系统的最高压力,同时可以防止上游水平管内出现高频率的长液塞流动。
- It was summarized in present paper that the liquid flow acted in the transfers process, solidification structure and componential segregation. 文章从传输过程、凝固组织和成分偏析等三个方面对液相流动的作用作了综述。
- The principles and methods of the design of gas and liquid flow deflectors and atomizer/spray nozzles have been demonstrated in the fluidized bed. 阐明了流化床聚合反应器中气液导流器和喷雾器的设计原理和方法,详细分析了操作工艺条件与产品质量和产率之间的关系。