您要查找的是不是:
- structural shear strength 结构抗剪强度
- Oh, J.K., and Shin, S.W., “Shear Strength of Reinforced High-Strength Concrete Deep Beams,” ACI Structural Journal, Vol. 98, No. 2, pp. 164-173 (2001). 蔡耀贤“高强度钢筋混凝土深梁之剪力强度”,国立台湾科技大学,营建工程系硕士论文,民国93年6月。
- In the process of the preloading, the shear strength of soils of foundation increased not only apparent but also structural in each filling consolidation pressure. 摘要在分期堆载预压过程中,地基土在某一堆载固结压力下,其抗剪强度不仅有表观强度上增长,而且有结构强度的增长(次固结作用)。
- Touch and close fasteners - Determination of longitudinal shear strength. 粘接拉链。纵向剪切强度的测定。
- The results show that the shear strength of COF is higher than that of COG. 结果表明 :COF比 COG的剪切强度高 .
- The shear strength of the composite is improved above to 11 MPa from 5.5MPa. 改性后碳 /聚芳基乙炔复合材料的剪切强度由 5 5MPa提高到 11MPa以上
- The shear strength of COG and COF bonded with ACF is studied by impact test. 摘要采用冲击试验方法研究了各向异性导电胶膜(ACF)互连的玻璃和柔性基板上倒装芯片(COG和COF)的剪切结合强度。
- The adhesive should preferably have a shear strength greater than 30 mpa . 粘结膜最好具有大于30毫帕的剪切强度。
- M.J.N. Priestley, F. Seible, R. Verma, and Yao Xiao (1994), “Seismic Shear Strength of Reinforced Concrete Columns,” ASCE Journal of Structural Engineering, Vol. 120, No. 8, August 1994, pp.2310-2329. 黄世建、方文宏、李宏仁,“钢筋混凝土低型剪力墙之之抗剪强度评估”,民国87年7月。
- Priestley, M.J.N., Verma, R., and Xiao, Y.(1994), "Seismic Shear Strength of Reinforced Concrete Columns," ASCE Journal of Structural Engineering, vol. 120, no. 8, pp. 2310-2329. 林正穆(2003),既有钢筋混凝土结构功能设计法耐震能力评估之探讨,硕士论文,私立中原大学土木工程学研究所,桃园。
- Indirect methods to measure the interface bond strength include the interlaminar shear strength test. 测量界面粘结强度的间接方法包括层间剪切强度试验。
- Ambitious attempts to improve interlaminar shear strength have been made by Mueller Prosen and by Keogh. 米勒·普罗森还有基奥都对提高层间切变强度作了大胆的尝试。
- Variation Rule of Shear Strength Index When Direct Shear Test of Coarse-grained Soil. 粗粒土直接剪切试验抗剪强度指标变化规律。
- Embedded columns can increase shear strength as well as control of displacement and failure. 配以暗框边柱能提高剪力墙的抗剪强度、位移控制和破坏控制能力。
- The wood is moderately hard and strong with high bending strength, shear strength and stiffness. 这类木材硬度适中而强壮,具有高度弯曲力、剪力和硬度。
- The melting point and the shear strength of Bi-Pb-Sn-Cd fusible alloys were determined by DSC and tension tester. 利用差热分析仪和拉伸试验机;研究了易熔合金Bi-Pb-Sn-Cd的成分对合金熔点和剪切强度的影响.
- Besides, the undrained shear strength was increased slightly due to the negative pore pressure. 不排水条件下由于负孔隙水压力的存在,土样的表观强度略有增大。
- The results showed that the shear strength of epoxy bonded joint decreased after it was aged in acid media. 结果表明,环氧胶接接头在酸性介质中老化后,其剪切强度明显降低;
- The results showed that the shear strength of fractal joints decreases nonlinearly as the filling percentage increased. 结果表明,随着充填度的增大,分形节理抗剪强度总体上呈非线性减小。
- Classical soil mechanics doesn't consider the influence of the matric suction in unsaturated soils on shear strength. 摘要:传统土壤力学并未考虑不饱和土壤中基质吸力对剪力强度之影响。