您要查找的是不是:
- steadystate cavitation 面气蚀
- Cavitation can be caused by a variety of reasons. 气穴可以由各种原因引起。
- Cavitation is noisy and easily detected by sonar. 空泡现象是有噪声的并且容易被声纳探测到。
- It explores the most conditions of cavitation. 探索了最优空化强化条件。
- Areas of necrosis and cavitation may occur within the tumor. 肿瘤内可以有坏死和成腔区。
- This is the basis of the phenomenon called cavitation. 这就是所谓汽蚀现象的根据。
- Windows SteadyState also enables you to restrict user access to local programs. 通过Windows SteadyState,您还可以限制用户访问本地程序。
- The total diameter of cavitation, if present, is less than 4cm. 若出现空洞,其直径总和小于4厘米。
- Excessive noise is an indication that cavitation is occurring. 噪音太大是发生空洞现象的一个征兆。
- Flow metering installation shall not cause flashing or cavitation. 流量表的安装不应引起闪蒸或气蚀。
- Cavitation damage was uneven and cavities appeared in local places. 空蚀破坏呈现不均匀性,局部区域出现大的空蚀坑。
- This is the basis of the phenomenon called cavitation . 这就是所谓汽蚀现象的根据。
- Lee L.WU T W.An enhanced CHIEF method for steadystate electrodynamics[J].Analysis with Boundary Element,1993,75-83. 黎胜赵德有.;用有限元/边界元方法进行结构声辐射的模态分析[J]
- For non-compressible fluids, where pressure drop causes cavitation or flashing. 对于不可压缩性流体,如果压降产生空穴或闪蒸。
- Excessive fluid noise is usually an indication that cavitation is occurring. 如果流体噪音过大,则通常意味着出现气穴现象。
- Windows SteadyState provides a more effective way to help defend shared computers from changes by untrusted users and unwanted software installations. Windows SteadyState提供了一种更为有效的方法,可帮助防止共享计算机被不可信的用户更改、或者安装不需要的软件。
- In both silicosis and CWP, these masses can undergo necrosis and cavitation. 无论硅肺还是CWP的大结节团块都可以出现坏死和空洞。
- Extremely high velocities should be avoided due to possible cavitation. 应该避免应用在可能出现空穴现象的流速异常高速的场合。
- The numerical investigation of steadystate situation is offered and the planar distribution of scattering light intensity is obtained. 计算表明,散射光场在入射面内呈现出“局部集中”的特点,而且由于“空间压缩”效应,使得获得的最大散射光强远大于初始泵浦光强。
- It presentsa better alternative to the unnecessary computational burden of arriving at a steadystate condition through a transient analysis. 它提供了一个更好的选择,对于用瞬态分析而达到稳态条件减少了不必要的计算。