您要查找的是不是:
- Control of Mold Sand Property Used for KW Static Pressure Molding Line KW静压造型线型砂性能控制
- static pressure molding line 静压造型线
- Transformation of Knock-Out System of Automatic High Pressure Molding Line 高压造型自动线落砂系统的改造
- The Upgrading and Application for the Hydraulic System of Shooting Pressure Molding Line 射压造型线液压系统的改造与应用
- Low pressure mold closing is standard . 低压开关模装置可保护模具的安全。
- high pressure molding line 高压造型线
- The static pressure at the sample surface is also recorded. 试件表面处的静压也能记录下来。
- Are mold lines indexing or continuous? 有标定指数的制模线吗?
- For best results in measuring static pressure, a piezometer ring should be used. 为了测静液压能取得最好的结果,应该用环形流压计。
- Fume hood shall be designed to minimize static pressure loss. Bell shaped exhaust collar configuration shall be provided. 通风柜的设计要减少静压损失。因此一般在排气口附件采用钟型设计。
- The characteristic of static pressure profiles in supersonic combustor was analyzed. 对超声速燃烧室内的静压分布特点作出了分析;
- Authors introduces an example of applying no-bake furan resin sand technology to large-scale and high-efficient molding line. 介绍了一种把呋喃树脂自硬砂工艺应用于大批量、高效率造型线的实例。
- A formula for calculating lateral static pressure on shallow silo wall is derived by global equilibrium method. 采用总体平衡方法给出了浅圆仓散体静态非线性分布侧压力计算公式。
- A coating, the coating - pressure molding of sheet metal, the coating should be visible to the naked eye, cracked concrete and scratches error. 有涂层、镀层的压型金属板成型后,涂、镀层不应有肉眼可见的裂纹、剥落和擦痕等缺陷。
- Technology of plate type steel castings produced by air impact molding line has been introduced with products meeting standard of AAR. 本文介绍了在气冲造型线上生产平板类铸钢件的铸造工艺。
- Experimental results show that the static pressure distributions are changed due to the coolant air. 实验结果表明,冷气喷射改变了叶片型面静压分布规律;
- But along with the raising of the exh aust air static pressure, the disturbance of noise also exceeds the limit. 但随着排气静压的提高,噪声干扰也明显超标。
- The structure characteristics,operation principle and application of the double-working position synchronous core-setting machine in SPO molding line were introduced in the paper. 介绍了同步下芯机的结构特点、工作原理以及在SPO造型线中的使用情况。
- When the fan is on, control strategy modulates the damper to maintain static pressure at the setpoint. 当风扇打开时,控制策略调节风门去维持设定点的静压。
- With introduction of HANSBERG injection molding line, the existent problems of the equipment have been pointed out then improvement aiming at these problems have been done. 本文通过对HANSBERG射压造型线的介绍,指出了设备存在的问题,并针对所存在的问题进行了改进。