您要查找的是不是：
- starter motor shift lever 起动机传动臂
- It must be the gear shift lever. 肯定是变速杆有问题。
- Solenoid or starter motor inoperative. 螺线管或启动器马达故障。
- PULL SHIFT LEVER TO LEFT SEVERAL TIMES TO ACTUATE DOWNSHIFT SWITCH. 把换挡叉杆向左拉动三次激活降挡开关。
- Drivers can use the standard paddle shifters or the shift lever. 驱动程序可以使用标准换档或转向杠杆。
- Remove starter motor (refer to Group 8B, Battery/Starter Service). 拆下启动马达（见单元8B，电瓶/启动马达维修）。
- WE NEED STARTER MOTOR ,IF YOU CAN SUPPLY ,PLEASE CONTACT US. 我们需要汽车起动机;请供应商联系我们.
- The indexing cam was in the rear derailleur rather than the shift lever. 分度凸轮的是在后方变速器，而不是变速杆。
- It had one headlight, no starter motor, and earned the nickname, “the tin can. 它有一个大灯，没有启动电机，而且被昵称为“马口铁罐头”。
- A protective covering, especially a sheath to enclose the base of a floor - mounted gear shift lever in a car or truck. 防护罩一种防护性覆盖物，尤指小汽车或卡车内一种用于包住登板或排档杆基部的套子
- Do not engage the starter motor for more than 30 seconds at a timAllow 2 minutes between cranking intervals. 起动马达啮合每次不能超过30秒。摇动曲轴间隔可为2分钟。
- In some cases, the shift lever may touch the monitor when moved to a certain position. 在某些情况下,当变速杆移到某一个位置时,可能和监视器相碰。
- The gear shift (linkage between the gear shift lever operated by the driver and the gearbox) must be fully mechanical. 波棍与波箱之间必须是机械式连接。(解析一下:某些高档轿车是用按键指挥波箱的侍服器)
- A protective covering, especially a sheath to enclose the base of a floor-mounted gear shift lever in a car or truck. 防护罩一种防护性覆盖物，尤指小汽车或卡车内一种用于包住登板或排档杆基部的套子
- The starting system consists of an electric starter motor and a starter solenoid. 启动系统由一个电动启动马达和一个启动螺线管组成。
- Parts of upper transverse arm shaft, front torsion bar cannular seat, shift plate, shift lever etc. 部分上横臂轴、扭杆前套管，变速平台、变速杆等零件。
- Manual valve is used to manually shift lever to manipulate the direction of spool control valve. 手动换向阀是用手动杠杆操纵阀芯移位的方向控制阀。
- That is fine for turning a starter motor, but it is not so good for powering an electric motor intended to move a car any distance. 这用在驱动启动马达上尚可，但是对于要牵引汽车行进一定距离的电动马达就不甚理想了。
- Hydraulic pressure dynamic cutting, match servo motor shift gears drive, double-pipe cutting, change from anomaly cut and hard to control the length of cutout. 液压式动态剪切，配合伺服马达驱动跟踪速度，双管切断，改善以往切口不工整及凸轮式剪切长度不好控制。
- The plunger's movement can also be used to do a mechanical job, such as shifting the starter motor gear in a solenoid-actuated drive. 柱塞通常是机械运动，就如使启动机挂挡的电磁驱动装置一样。
