您要查找的是不是:
- standard test voltage 标准测试电压
- Guide To Standard Test Of English Listening II. 标准化英语水平考试听力指南2。
- The resistor is first measured with test voltage V1, giving R1. 首先在测试电压V1之下测量电阻器,得到R1。
- Spark test voltage values given by the potential difference between the test electrode and the conductor of the core or cable under test shall be specified in the cable standard. 火花试验时,电极与被测试电线或电缆之间的电位差的值在电线标准中有明确规定。
- When verifying by test: RAL-UZ-38( German standard test method). 测试验证时:RAL-UZ-38(德国标准测试方法)
- Test Voltage of Loading at high temperature test is 1.5 Time of the rated voltage. 高温负载试验电压为额定电压的1.;5倍。
- ASTM E813-1989. Standard test method for JIC, a measure of fracture toughness. 惠虎.;解理断裂局部法理论的关键技术改进及应用研究:[博士学位论文]
- De-energize Ch. 42, then open Ch. 1 and close Ch. 2 to apply the test voltage to terminal 3. 释放通道42,然后开路通道1,并闭合通道2,向端子3上施加测试电压。
- Standard Test Method for Density of Plastics by the Density-Gradient Technique. 用密度梯度法测定塑料密度的试验方法。(英文版)。
- With this method, the user enters the test voltage, measurement time and the number of iterations. 使用这个方法,用户输入测试电压、测量时间和重复次数。
- The Reform of Standardized Test in the U.S. 美国标准化考试改革。
- The voltage rating of these resistors must be at least equal to the test voltage. 这些电阻器的电压额定值必须至少等于测试电压。
- Next, it is measured with test voltage V2 (where V2is greater than V1), giving R2. 接着在测试电压V2之下(V2大于V1)测量电阻器,得到R2。
- Note the exponential decay in the current using both a positive and a negative test voltage. 注意在使用正、负测试电压时电流的指数衰减情况。
- This application employs a Model 6517A Electrometer, which can supply the test voltage and measure the residual voltage. 这种应用情况使用了一台6517A型静电计,它能够供给测试电压并测量剩余电压。
- The test voltage shall be the nominal system voltage corresponding to the ballast input voltage rating, as specified in Table 16.3.3.1. 如表16.;3
- The Standard Test is a paper-based test of overall language ability in the workplace. 综合化测试是一项以纸笔来进行的考试,测试考生在日常工作环境中的总体语言技能。
- Welds standardized test plates for Code conformance. 按规范焊接标准的检验样扳。
- Most standardized tests are summative. 大多数标准化测验都是终结性的。
- Multifunction of testing voltage value, current value, RF value and transient current strength. 多用途测试电压值,电流值,射频值及瞬变电流强度等。