您要查找的是不是:
- source address instruction 源地址指令
- Specify correct scope-id or use -s to specify source address. 请制定正确的作用域id或使用-s来制定源地址。
- The SA field is the source address field of the ISL packet. (SA字段是ISL包的原地址字段。
- Copies a specified number bytes from a source address to a destination address. 将指定数目的字节从源地址复制到目标地址。
- Standard ACLs check the source address of IP packets that are routed. 标准ACL检查被绕送IP封包的来源位址。
- Use an ingress filter on your network to ensure that no packets enter your outside boundary with a source address of your internal network. 在网络中使用入口过滤器来确保没有使用你的内部网络的源地址的包进入你的外界。
- The information available is the source address,the source port,the destination address,and the destination port. 可得到的信息为: 源地址,源端口,目的地址,目的端口。
- Each packet carries a source address,which under current (IPv4) specifications is 32 bits long. 每个包携带一个源地址,在目前(IPv4)规范下,包长度是32位。
- Use an egress filter on your network to ensure that no packets leave your network with a source address that isn't a part of your internal network. 在网络中使用出口过滤器来确保没有使用不属于你的内部网络的源地址的包离开你的网络。
- Our handy locators allow you to source address information for DHL offices across the world. 我们便利的地点搜索工具可以为您提供DHL在世界各地的办公地点的地址信息。
- The third command specifies that this rule will match any packets not from source address 203.16.1.89. 第三条命令指定该规则将与除来自源地址203.;16
- three plus one address instruction 三加一地址指令
- Each packet carries a source address, which under current (IPv4) specifications is 32 bits long. 每个包携带一个源地址,在目前(ipv4)规范下,包长度是32位。
- To configure dynamic inside source address translation, perform the tasks in Figure . 执行图当中的步骤,可以进行动态内部起始地址转换的组态设定。
- format implicit address instruction 格式隐地址指令
- The number in parenthesis represents the source address encapsulated into the IP header of the RIP update. 括弧内的数字代表封装在RIP更新的IP表头之来源位址。
- four-plus-one address instruction 四加一地址指令
- four-plus-one address instruction format 四加一地址指令格式
- Source Address: This field has 16 octets or 128 bits. It identifies the source of the packet. 源地址:这个字段有16个8位组或128彼特.;它确定这个包的来源
- The IP address will not be used by applications as source address for outbound packets. 意思是测试地址不会被应用程序作为发送数据包的源地址。