您要查找的是不是:
- solution treatment temperature 固溶温度
- The high temperature near-solvus pre-precipitation following higher temperature solution treatment were performed on LC52 and Quansi 7039 aluminum alloy. 研究了高温固溶后降温处理工艺对中强可使预析出LC52和7039铝合金的组织、时效硬化和应力腐蚀的影响。
- Effects of solution treatment on the microstructure and martensitic transformation start temperature Ms of Ni47 Ti44 Nb9 shape memory alloy have been investigated by means of SEM and differential scanning calorimeter (DSC). 本文用扫描电镜和差示扫描量热仪 (DSC)研究了固溶热处理对Ni47Ti44Nb9记忆合金显微组织和马氏体相变开始温度Ms点的影响。
- HT Sub-factory : complete process of annealing, quenching, tempering, quenching and tempering, solution treatment etc. 热处理厂:可完成退火;正火;回火,调质;固溶处理等工艺.
- The effect of subzero treatment temperature on the fatigue property of the ultra-high strength steel B318 was studied. 研究了冷处理温度对超高强度钢B318疲劳性能的影响,结果表明,在相同条件下,冷处理温度对该钢的疲劳性能影响很大。
- As the thermal treatment temperature of Ti-MMT increased, the adsorption of arsenate in water obviously decreased. 随着对钛柱撑蒙脱石热处理温度升高,材料对水体中砷酸根的吸附能力呈明显下降趋势。
- Adding elements of Zr and Cr can increase the tensile strength, and electric conduction can be improved by solution treatment. 同时,铬和锆的存在可提高合金的抗拉强度;采用固溶处理使合金具有高导电性能。
- The heat treatment temperature of EMD in Li-MnO2 batteries has great effects on comprehensive electrical performance of batteries. Li-MnO2电池用电解二氧化锰(EMD)的热处理温度对电池的综合电气性能有较大的影响。
- The heat treatment technology of carbo - nitriding of steel has the characteristic of lower treatment temperature and direct quenching. 钢的碳氮共渗热处理工艺具有共渗温度低、可直接淬火等特点。
- Intermetallic compound foam reinforced aluminium alloy surface composite layer are obtained by solution treatment after low pressure Casting. 通过低压铸造后固溶处理的方法,获得了网状金属间化合物增强铝合金表面复合层。
- During the fast cooling process of solution treatment, nonequilibrium segregation of manganese was produced at austenite grain boundaries. 在固溶处理时快速冷却过程中锰在奥氏体晶界产生不平衡偏聚。
- Increasing the semisolid isothermal heat treatment temperature can promote solute diffusion and quicken grain spheroidization speed. 提高半固态等温处理温度能促进溶质的扩散,加快晶粒的球化速度。
- The effects of doping ratio and heat treatment temperature on the structure and the electrical conductivity of ATO powder were studied. 研究了掺杂比、热处理温度等工艺条件对ATO粉体结构和导电性能的影响。
- After the homemade welding building of the lead liquid pool of austenitic stainless steel,solution treatment is demanded. 奥氏体不锈钢铅液池进行国产化制作,要求焊接后进行固溶处理,固溶处理后经探伤发现焊缝上有大量的裂纹。
- The -phases almost all soluble in -Mg after solution treatment and the mechanical properties improve slightly while the grain size tends to coarsening. 合金经固溶处理后 相几乎完全溶于 -Mg固溶体,但晶粒尺寸有粗化倾向,合金的力学性能略有提高。
- The results from TGA show that the reactivity of the chars from YXV and JJV decreases with the increase of heat treatment temperature. TGA结果表明,热处理温度增加,蔚县煤镜质组(YXV)与湔江煤镜质组(JJV)焦炭的反应性降低;
- With the growth of heat treatment temperature or time, the crystallinity increase and the spherulite size and its distribution has a little change. 热处理温度的提 高或时间的延长均使结晶度逐渐增大,但平均球晶尺寸和球晶分布宽度变化不 大。
- After the solution treatment(20h),the Mg_(17)Al_(12) phase is almost dissolved,but the black particle quasicrystal phase is not dissolved and retained stability. 固溶处理(28 h)后,Mg17A l12相基本溶解,黑色的颗粒状准晶相在固溶处理过程中保持稳定而未溶解。 固溶处理对合金的硬度影响不太明显。
- The possibility of manufacturing 2205 duplex stainless steel (DSS) by accelerated cooling control (ACC) process without solution treatment was investigated in this paper. 摘要本文探讨以加速冷却制程生产2205不锈钢而省略固溶化处理之可行性。