您要查找的是不是：
- At present, the extensive industrial method to produce silicon carbon are Acheson and Multi-thermal Source process. 目前，大规模工业生产SiC的方法有Acheson法和多热源法两种。
- At the present time, the industrial method to produce electrical silicon carbon is only Acheson process. 目前,工业生产电工 SiC 的方法只有 Acheson 法。
- MnO_2/ carbon composites were prepared by using Mn(AC)_2 to deoxidize KMnO_4 with active carbon. 以草酸锰(Mn(AC)_2)还原KMnO_4制备MnO_2，同时添加活性碳，制备了MnO_2/碳复合电极材料。
- But electrical silicon carbon synthesized by Acheson process is of high power consumption, low yield, low-grade and high-cost. 但以 Acheson 法生产的电工 SiC 能耗高、产量低、质量差,生产成本居高不下。
- Rossy’s wing was made from carbon composite. 罗斯的“翅膀”是由碳的混合物做成的。
- Xu H J,Xiong X,Huang B Y,et al.Friction properties of carbon carbon composites with different pyrocarbon structure[J].Tribology,2003,23(4):344-349. [2]徐惠娟;熊翔;黄伯云;等.;不同热解炭结构的炭炭复合材料的摩擦特性[J]
- The graphic analyzer was used to analyze the particle size of emulsion.The interlaminar shear strength (ILSS)of carbon composites was measured. 用图象分析仪对乳液粒径进行分析,并测定了碳纤维复合材料的层间剪切强度。
- Effects of porosity on the material performance of chopped high modulus carbon fiber reinforced carbon composites and carbon materials were studied. 研究了短切高模碳纤维增强碳复合材料和碳基体材料气孔率对材料力学性能的影响。
- Granular coke reinforced pitch-based carbon composites (CRPCC) with high density and low cost were fabricated by a new mould pressing and semi-carbonization technique. 摘要采用新型的模压半炭化成型工艺在大气环境下制备出了高密度、低成本的焦炭颗粒增强沥青基炭复合材料(CRPCC)。
- The kiln is made up of body, pushing board ,slide-road board, pushing car, silicon carbon heating stick, control system and ventilation system etc..The pushing board ,slide-road board use SIC. 该窑炉由窑体、推板、滑道板、推车机、硅碳棒发热元件、控制系统及通风管路等部分组成。
- Based on the Jaguar XK models produced between 1997 and 2005, the Arden model was built with carbon composites custom manufactured at the company's headquarters in Krefeld. 基于捷豹XK车型从1997年到2005年，雅顿模型建立的碳复合材料制造的习俗在该公司总部设在克雷费尔德。
- Wang Y G,Wang Y L,Wu G S.Tribological properties of 3-D carbon composites under lubricated condition[J].Journal of Materials Science &Engineering,2005,23 (1):12-14. [4]王玉果;王玉林;吴广顺.;润滑条件下三维编织碳复合材料的摩擦学特性[J]
- AX L.LAKE.Vapor-grown carbon-fiber reinforced carbon composited[J]. 马伯信;金志浩.;碳碳复合材料的新发展[J]
- silicon carbon semiconducting ceramic 碳化硅半导瓷
- A multi layer coating with a SiW outer layer by liquid reaction formation method was prepared for carbon carbon composites,and then the structure of the oxide film on the coating was investigated by XRD,SEM,Raman spectrum and electron probe. 研究了一种液相法及其它方法制备的碳碳复合材料多层防氧化涂层，并用XRD，SEM，Raman光谱和EMPA研究了液相法制备的SiW涂层表面氧化后的结构。
- silicon carbon rod heating furnace 硅碳棒式电加热炉
- MnO_2/activated carbon composite electrode materials were also prepared by chemical co-precipitation method. 利用化学共沉淀法合成了MnO_2与活性碳复合材料。
- Active Carbon deodorizer contents activate carbon composition, make deodorant effect more obviously. 活性碳消臭剂添加活性碳成分，使消臭效果更为明显。
- The silicon chips are less than a millimeter thick. 这些矽片厚度不足一毫米。
- This paper reports the analyses of the low carbon compositions in fusel oil by using gas chromatographic technique. 本文报导气相色谱法分析测定杂醇油中低碳成分的测定条件和分析的准确度的评价。
