您要查找的是不是：
- signal point indicator lamp 道岔表示器灯
- signal point indicator 道岔表示器
- Entered the working state.The indicator lamp of “J1” or “J 2” light if relay 1 or relay 2 acting else go out. 位选键（）：当进入编程状态时，数码管中有一位闪烁，通过此键可使闪烁位从高位向低能位循环移动。
- Method Displaying the level of myoelectricity reaching by rsing the color changes of indicator lamp as feedback signals. 方法利用肌电训练康复仪，通过对残肢者残端训练时指示灯的颜色变化作为反馈信号，显示肌电发放已达到水平。
- The first twofigures after the decimal point indicate tenths and hundredthsrespectively. 小数点后的头两位数分别表示十分位和百分位。
- The built-in component is: Omnipotent change-over switch, press the button,an am-pere meter , Indicator lamp wait, can install other instrument according to user"srequest. 可实现各种元件的任意组合， 满足用户设计要求。
- The SSN identifies the SCCP user at a signaling point. SSN 在信令点识别 SCCP 用户。
- When power indicating lamp lighting, the equipment processing power. 电源指示灯亮，装置即接通电源。
- Many charging circuits use an indicator lamp to indicate whether or not the alternator is charging the Battery. 许多充电电路用一指示灯来显示发电机是否在给蓄电池充电。
- Link Status Signal Units (LSSU) - transport link status information to an adjacent signaling point. 链路状态信令单元 (LSSU) -- 将链路状态信息传输到某个相邻的信令点。
- Their faint, red turnoff points indicate that. 它们又暗又红的转折点说明了这一点。
- The number of indicator lamps in conventional dashboards is increasing. 在常规仪表板上指示灯的数目不断增加。
- A red lamp is often a danger signal. 红灯常常是危险的信号。
- Use the points indicated by the arrows. 用箭头指示的点。
- With the handwheel/turn indicator sleeve assembly still at its balance set point indication, reinstall them on the valve stem and hold in place with the 1/4" retaining bolt. 这时手轮/旋转指示器套筒总成仍然位于平衡设置指示点上，将它们重新安装到阀杆上，并用1/4英寸固定螺栓固定在其位置上。
- A red lamp is used as a danger signal. 红灯用作危险信号。
- Generally,this is the point code of the next signaling point that will pass the message to the terminating destination. 通常，这是将要传送消息至最终目的地的下一个信令点。
- Network traffic between signaling points is handled via a packet switch. 信令点之间的网络流量是通过包交换机处理的。
- While simulates low oil temperature conditions, the indicating lamp should light up and holding of main engine start message should be allowed. 模拟油温低、指示灯亮且允许主机启动信号不能发出。
- The first two figures after the decimal point indicate tenth and hundredth respectively. 小数点后的头两位数分别表示十分位和百分位。
