您要查找的是不是:
- Based on Matlab RTW semi-physical simulation platform,a siding mode control algorithm is presented for a kind of uncertain time-delay system. 针对一类不确定时滞系统研究滑模控制的实现问题。
- siding mode control 滑模控制
- Aldrin: Mode Control, both Auto. 阿尔德林:方式控制,双双自动。
- Switch to connect mode, using the Display Mode control. 使用“显示模式”控件切换到连接模式。
- Furthermore, burst mode control is utilized for dimming function. 除此之外,亮度的调节采用的是间歇式调光。
- A strategy for integral separation PID sliding mode control is proposed. 摘要提出一种积分分离PID滑模控制策略。
- The Application of Fuzzy Sliding Mode Control in Network Congestion Control P. 模糊滑模控制在网络拥塞控制中的应用。
- Mode control and the micro-computer are optional , and depend on the equipment . 模式控制和微型计算机通过设备是可选择的。
- Aldrin: Mode Control, both Auto. Descent Engine Command Override, Off. Engine Arm, Off.413 is in. 阿尔德林:方式控制,双双自动。登陆引擎命令飞跃,脱开!引擎臂,脱落。413,进入。
- Disconnect the vacuum harness connector from the back of the heater-A/C mode control switch on the control panel. 从控制仪表板上的空调暖气模式控制开关上断开真空线束接头。
- In the tuning range, the EML output power variation is less than 3 dB, the extinction ratio variation is very little and the side mode suppression is maintained more than 30 dB. A wavelength fast tunable EML by using phase tuning is also proposed. 在调谐范围内,激光器输出功率的变化小于 3dB。
- Single mode emission of an external cavity laser was obtained experimentally at 1 GHz modulation with side mode suppression ratio better than 40 dB, 3 dB dynamic line width about 0.1 nm, and 20 dB dynamic line width about 0.3 nm. 对所研制的光纤光栅外腔激光器进行了高频调制测量 ;得到了在 1GHz下的单模激光输出 ;边模抑制比在 40dB以上 ;3dB动态线宽为 0 .;1nm左右;2 0dB动态线宽为 0
- Click End Connection, and then use the Display Mode control again to return the page to browse mode. 单击“结束连接”,然后再次使用“显示模式”控件使该页返回到浏览模式。
- The results show that the fuzzy sliding mode control method in the slip ratio control of ABS is valid. 结果表明,模糊滑模控制方法在ABS的滑移率控制中是切实有效的。
- Aldrin:Mode Control,both Auto.Descent Engine Command Override,Off.Engine Arm,Off.413 is in. 阿尔德林:方式控制,双双自动。登陆引擎命令飞跃,脱开!引擎臂,脱落。413进入。
- This thesis presents the application of the sliding mode control to the magnetic amplifier (magamp) post regulator. 本论文提出应用滑动模式控制于磁放大后级稳压器上。
- Then the sliding mode control will be constructed on the feedback linearized system to against the model uncertainties. 藉著对本系统的非线性磁力模型仔细的校准,使得我们可以精确的表达出实际的系统模型。
- And about the control theory, the sliding mode control has better adaptability and application. 就控制理论而言,滑模控制具有较强的鲁棒性和应用性。
- The deer was peppered with shot all down one side. 那只死鹿的半边身子都被子弹击中。
- Reset the control by changing the Mode Control to another mode and returning to the original operating mode. 通过重置,将控制模式从一种模式改变到另一种模式,并回到原始运行模式。