您要查找的是不是:
- side impacting force 侧向冲击力
- These are to protect the pilot from side impact. 这些都是为了保护试点从侧面撞击。
- Mo dels for calculating impact force were regressed. 刚性冲击时可利用与冲击动能有关线性模型计算冲击力;
- Analysis Model of Fabrics on Impact Force when Airbag Inflates at High Speed. 安全气囊高速膨胀时冲击力分析模型。
- Provides top, front, rear and side impact and penetration protection. 钢盔提供顶部,前面,后面和两边对于撞击和被对象穿透的保护。
- The e-quations of impacting force changing with nozzle inclinationangle, azimuth, coede position and jet velocity have beengotten by multivariate statistic analysis. 通过对实验数据的多元统计分析,得出了各钻头齿受纵向清洗力随水力结构及喷速变化的关系式。
- The explosives can be detected for the impact force of their deflagration with the modified cantilever. 为了更进一步提高检测灵敏度,本文还提出了一种改进型悬臂梁的研制。
- The car is fitted with side impact bars(= to protect it from a blow from the side). 这辆车的两侧都安装了保险杠。
- Comparing the difference of the side impact standards with respectedto ECE R95 and FMVSS 214. 对国际上侧面碰撞法规ECE R95和FMVSS 214进行了的全面的对比。
- The 3-year-old restraint was very poor in the frontal crash and failed to contain the head in side impact. 3岁儿童座椅固定在正面碰撞中非常差,侧面碰撞中儿童头部甩出了座椅。
- Note: It shall loosen/tighten slowly with the jack lever instead of the impact force during the use of torquer. 注意:在使用增扭器时不要使用冲击力,只需用加力杆缓缓旋松、旋紧即可。
- The relation of the impact force on the chin with time pulse was represented as approximately half sine. 实验描述了下颌骨在撞击作用下的动态响应规律,表明颏部所承受的撞击力大小与时间成半个正弦波函数关系。
- The NHTSA gave the 2009 Audi Q5 five stars for both driver and passenger protection in front and side impact tests. 在给美国国家公路交通安全局2009年奥迪Q5五颗星为保护司机和乘客在正向和侧面撞击试验.
- Pull force, jar placement, collar dimensions and depth of fish are related to the impact force. 上提拉力、上击器安放位置、钻杆尺寸以及落鱼深度等都影响到震击力大小的确定 .
- A high sweet spot, i.e. a center of percussion close to the tip of the racquet is good because it means low Impact Force. 甜点在这条轴线上的位置越高(离手越远,离拍头越近),就越好。
- This meant that the car had front and rear crumple zones, side impact protection, a protected fuel tank and bolt-on front wings. 这意味着车了前后 crumple 区域、 侧影响保护、 受保护的油缸和螺栓对前翅膀。
- The impact force and pressure are described about the pre-mixed abrasive waterjet. 介绍了前混合磨料清砂的冲击力和冲击压强。
- Mooring ship's impact force under wave's action is usually the control load of large open wharf's design. 摘要系泊船舶在波浪作用下的撞击力往往是大型开敞式码头设计的控制荷载。
- Cold stamping allows the production of simple shapes with very high strength, up to 1,200 megapascals (MPa) (about 175 kilopounds per square inch), such as side impact beams. 用冷冲压的方法可以使形制简单的零件具有很高的强度,可达到1200MPa。
- Deshpande B R,Gunasekar T J,Gupta V,et al.Development of MADYMO Models of Passenger Vehicles for Simulating Side Impact Crashes[ C].SAE Paper 1999 -01 -2885. 张建伟.;基于数值模拟技术提高微型客车正面抗撞性的研究[D]