您要查找的是不是:
- saddle pivot pin 鞍座系紧螺栓,鞍座支销
- Place a pivot pin into the pivot point. 把大头针扎在旋转点上。
- Place a pivot pin into the bp. Mark the curved line A-bp.onto the pivot paper. 在胸点上孔一枚大头针。在旋转纸上画出A到胸点的弧线。
- Place a pivot pin into the BP. Mark the curved line A-BP onto the pivot paper. 在胸点上孔一枚大头针。在旋转纸上画出A到胸点的弧线。
- Lay the front bodice on a clean sheet of paper and place a pivot pin into the bust point. 把前身样板放在一张透明纸上并把大头针孔在胸点处。
- Pivot pins are constructed of stainless steel. 枢轴销采用不锈钢结构。
- Thoroughly clean and liberally grease pivot pin and lightly tap in a straight line without pausing. 彻底清洁枢轴并到处涂上润滑油后沿直线不停轻拍。
- This paper analyzes and compares the ordinary heat treatment technology of Q275 steel knuckle pivot pin with the quenching and backfiring technology. 摘要分析、比较了Q275钢钩尾销普通热处理工艺与锻热淬火+回火工艺。
- Therefore, it is suggested that knuckle pivot pin should be heat treated by the adoption of the quenching technology of heat forging and backfiring. 故提出对钩尾销采用锻热淬火+回火的热处理工艺。
- Drop tight seating is accomplished over the full pressure range because a slight clearance at the pivot pin assures complete seating between the disc ring and body ring. 由于在枢轴销上的空隙很小,所以在整个压力范围内都可以实现漏斗形紧密阀座密封,确保阀瓣环和阀体环之间的阀座密封的完整性。
- This construction avoids the need for extending the pivot pins through the valve body. 这种结构消除了将枢轴销伸长穿出阀体的必要性。
- The seat, disc and pivot pins are combined into one subassembly secured to the inlet side of the body with a locking ring in sizes 3" and smaller. 阀座,阀瓣和枢轴销构成一个分总成,采用尺寸3英寸或更小的锁环固定在阀体进口一侧。
- He is determined to stay in the saddle at all cost. 他打定主意要不惜一切代价继续掌权。
- After many hours in the saddle he was very weary. 骑马骑了几个小时后,他非常疲倦。
- Better lose the saddle than the horse. [谚]宁可丢鞍,不可失马。
- Fasten the saddle on the horse's back. 把鞍子系在马背上。
- Tell him to catch the ponies and saddle up. 叫他牵住小马并套上马鞍。
- Let's pin the notice on the bulletin board. 咱们把这个通知钉在布告牌上吧。
- The saddle galled the horse's back. 马鞍擦伤了马背。
- I prick the map with a pin to show our route. 我用大头针在地图上扎孔标出我们的路线。