您要查找的是不是:
- Application of Fuzzy Neural Network on Rolling Speed Control 基于模糊神经网络驼峰溜放速度的控制
- In many speed control systems, e.g., rolling mills, mine winders, etc. 在许多速度控制系统中;例如轧钢机;矿井提升机等负载要求频繁地停机和反向运转.
- The influence of rolling speed is not distinct. 轧制速度对界面结合的影响不明显。
- The drill has variable speed control. 这钻机有变速控制。
- Design of Speed Control System for Full. 实车碰撞车速控制系统的设计。
- Three stages wind speed control. 三段风速控制。
- Speed control systems will be built into cars. 汽车中将装有速度控制系统。
- At a low steel rolling speed, the traditional AGC feedback control is not very good due to a long time delay caused by the thickness measurement. 在低速轧钢时,由于测厚仪测量值的长时间滞后,传统的后馈控制效果不好。
- LRP "Ai" digital speed control, installed. LRP的“爱”数字速度控制,安装。
- The use of motor speed control, automatic cycloid. 采用可调速电机,自动摆线。
- Select the Rolling Speed at the pull down menu, then hold down the left click on the [ Rolling Up ] or [ Rolling Down ] to control the destination blind. 于下拉选单选好搅动速度后,用滑鼠左键按下[上移]或[下移]控制地点牌。
- It is pointed out that like the barrel type piercer process,the control of the cone type piercer roll speed is also very important. 指出了锥形辊穿孔机也要和桶形辊穿孔机一样,要重视对穿孔机轧辊转速的控制。
- The automatic current control and speed control of decoiler in pickling and cold rolling line are introduced. 介绍了配洗连轧线开卷机的自动电流控制和自动速度控制模式。
- The speed control strategy of mills and tabs in rough rolling section and APC strategy are given. 将磁致位移传感器成功地应用到轧制生产中,提高了辊缝测量精度;
- Speed control switch input above the maximum acceptable voltage. 速度控制开关输入高于最大可接受电压。
- Install throttle cable, vehicle speed control cable (if equipped). 安装节气钢缆、车速控制钢缆(如果装备)。
- The splitting rolling technology was applied to reso lve the problems of slow rolling speed, low productivity, etc. 针对嘉良钢铁公司棒材半连续式水平连轧机组轧制速度慢、产量低等问题,采用了切分轧制技术;
- Speed Control of Induction Motor Based on Passivity Theory P. 基于无源性理论的异步电机的转速控制。
- While the rolling speed exceeds 2 m/s, the variation of heat drop gradually tends to become gentle. 制订轧制规程时,出炉温度可选择合理范围内的较低值以降低能源损耗;
- Conveyor speed can be configured to speed or speed control mode. 输送机的速度可配置成定速或可调速的控制方式。