您要查找的是不是：
- relay control register 继电器控制记发器
- MEASURE THE INTERMITTENT WIPER RELAY CONTROL CKT. 测量间歇的雨刷继电器控制电路
- HI/LO WIPER RELAY CONTROL (CAV 12). HI/LO雨刷继电器控制（12孔）。
- No interference between relay control and aliases. 转信控制与别名无冲突。
- HI /LO WIPER RELAY CONTROL (CAV 12). LO雨刷继电器控制（12孔）。
- relay controlling register 继电器控制寄存器
- relay controller register 继电器驱动装置寄存器
- MEASURE THE VOLTAGE AT THE TRANS RELAY CONTROL CIRCUIT AT TCM. 测量TCM的变速继电器电路的电压。
- MEASURE THE RESISTANCE OF THE HORN RELAY CONTROL CKT. 测量了继电器控制电路。
- USING THE SCHEMATIC, REPAIR THE OPEN DECKLID RELEASE RELAY CONTROL CKT. 使用图表，修理断开的活动车顶释放继电器控制电路。
- WITH THE DRB IN VOLTMETER MODE, PROBE THE ABS SYSTEM RELAY CONTROL CKT. 用DRB的伏特计模式，探测ABS系统继电器控制电路。
- PLC or Relay control with optional operation of manual and semi-auto. 有电脑、继电器两种控制方式,设有手动、半自动两种操作方式。
- Relay control--stops unauthorized relaying by outsiders. 转信控制--阻止未授权的外来转信请求。
- The first notch of this digital filter can be programmed via the on-chip control register allowing adjustment of the filter cutoff and settling time. 此数字滤波器的第一个陷波可通过片内控制寄存器进行编程，以便对滤波器截止和建立时间进行调整。
- SPI register configuration platform achieve RS232 interface for data transmission equipment to the SPI bus to visit and control register of the base band signal processor. SPI寄存器配置平台实现了RS232接口设备到SPI总线的数据传输,从而完成对OFDM基带信号处理器中状态寄存器的访问与控制。
- This paper shows in detail the workings of PCI9054, the configuration of its control register, and the writing of platform driver with API functions provided by the manufacturer. 利用PCI接口芯片的强大功能，本文提出了采用DMA模式双向传输DSP平台的高速数据，采用从模式传输初始化信息及配置信息等低速数据，并详细介绍了PCI9054的工作方式，控制寄存器的配置以及调用厂商提供的API函数编写平台驱动程序。
- According to the actuality of the diagnosis of relay control circuits,the paper presents an interactive diagnosis method. 文章针对继电控制电路故障诊断的现状,提出交互式故障诊断的思想。
- The first notch of this digital filter can be programmed via an on-chip control register allowing adjustment of the filter cutoff and output update rate. 此数字滤波器的第一个陷波可通过片内控制寄存器进行编程，以便对滤波器截止和输出更新速率进行调整。
- Separates with the metal partition board the switch cabinet in vivo part for the circuit breaker room, the host generatrix room, the cable vault and the relay control room. 用金属隔板将开关柜体内部分隔为断路器室、主母线室、电缆室和继电器仪表室。
- The ladder diagram can be designed and be run basing on the relay controlling circuit. 在继电器控制线路的基础上,设计出梯形图并进行现场调试。
