您要查找的是不是:
- rear link set 后方通信连络台
- Signaling Link Code = the member number within a link set. Signaling Link Code = 链路群内的成员号。
- The alternate link set must not be equal to the preferred link set. 交替链路群的值一定不能与首选链路群相等。
- A combined link set provides alternate paths between two SS7 nodes. 合并的链路群提供两 SS7 节点之间的交替路径。
- This value must be different from the other two link set values. 该值必须和其他两个链路群的值不同。
- Align mark on the rear link yoke and universal joint to the mark on the transfer case yoke. 将后连接轴轭和万向节上的标志与传动箱轴轭上的标志对准。
- Signaling Link Code--he member number within a link set. Signaling Link Code -- 链路群内的成员号。
- Link Set = the link set to which this specific link belongs. Link Set = 该特定链路属于的那个链路群。
- A link set may consist of up to 16 links. 一个链路群可能由 16 条链路组成。
- Preferred Link Set-the preferred link set is specified in this field. Preferred Link Set -- 在该字段指定首选的链路群。
- All 16 links can be assigned the same link set number. 全部16 条链路会分配到同一个链路群号码。
- Link Set--this is a number identifying the link set to which this particular link belongs. Link Set -- 这是识别该特定链路所属链路群的一个号码。
- For non-STP applications (such as the 5ESS DCS) that do not have a combined link set,this field must be set to 0. 对于没有组合链路群的 STP 应用程序(比如 5ESS DCS),必须将这个字段设置为 0。
- This value must be unique within a link set and must agree with information in the far end STP or 5ESS DCS. 在链路群中,该值必须是唯一的,而且必须与远端 STP 或 5ESS DCS 上的信息一致。
- Link Set-this is a number identifying the link set to which this particular link belongs. Link Set -- 这是识别该特定链路所属链路群的一个号码。
- Alternate Link Set-the alternate link set to be used in routing flag (DLS_RTG) case. Alternate Link Set -- 交替链路群设置为用于路由标志为 (DLS_RTG) 的情况下。
- For non-STP applications (such as the 5ESS DCS) that do not have a combined link set, this field must be set to 0. 对于没有组合链路群的 STP 应用程序(比如 5ESS dcs),必须将这个字段设置为 0。
- Alternate Link Set 裈he alternate link set to be used in routing flag (DLS_RTG) case. 交替链路群设置为用于路由标志为(DLS_RTG)的情况下。
- A body of the enemy hung upon their rear. 一伙敌人紧紧地跟在他们的后面。
- When a process terminates it sends an exit signal, either normal or non-normal, to the processes in its link set. 当一个进程终止的时候,它发出一个退出信号(不论是否正常退出)到和它链接在一起的所有进程。