您要查找的是不是：
- The reasonable axial compression, load angle and the ratio of stirrup of special-shaped columns are gained from the contrastive analysis. 通过对比分析，得出了异形柱比较合理的轴压比和加载角度。
- By taking axial compression ratio, local angle, stirrup space, the ratio of stirrup and etc. into consideration, the author studies the displacement ductility ratio for speical-shaped columns such as L shape, T shape and t shape. 摘要通过考虑不同轴压比、不同加载角度和不同配筋率等情况，对异形柱位移延性比进行了研究。
- By muting certain requirements of ductility, the limit values of axial compression ratio of C80 SRHC columns are put out, and the influence of stirrup ratio on it is also analyzed. 在满足一定位移延性的基础上;提出了C80型钢高强混凝土柱的轴压比限值;并就配箍率对轴压比限值的影响进行了分析;进一步提出了与不同配箍率相关的轴压比限值.
- The ratio of students to teachers is 35:1. 学生和老师的比率是三十五比一。
- The ratio of schoolboys to schoolgirls is 2 to 1. 男学生和女学生的比例是2比1。
- Men outnumber women here in the ratio of three to one. 此地男子数量以三比一超过女子。
- The ratio of men to women was two to one. 男女的比例是二比一。
- INFLUENCE OF STIRRUP RATIO ON LIMITING VALUE OF RATIO OF AXIAL COMPRESSION STRESS TO STRENGTH FOR STEEL HIGH-STRENGTH CONCRETE COLUMNS 配箍率对钢骨高强混凝土短柱轴压力系数限值影响的试验研究
- 8.The reasonable axial compression, load angle and the ratio of stirrup of special-shaped columns are gained from the contrastive analysis. 通过对比分析，得出了异形柱比较合理的轴压比和加载角度。
- The ratios of 1 to 5 and 20 to 100 are the same. 1与5之比和20与100之比相同。
- The strike is the ultima ratio of Trade Unionism. 罢工是工联主义的最后手段。
- This is the prime ratio of the nascent increments. 这是最初增量的最初比。
- Besides, increase of stirrup ratio and longitudinal bars in the end of web also have effect on the ductility of the columns. 增大配箍率及端部加强纵筋对试件的延性有一定的改善。
- Compression ratio of the server input data stream. 服务器输入数据流的压缩比率。
- Compression ratio of the server output data stream. 服务器输出数据流的压缩比率。
- Low utilization ratio of healthcare resources. 卫生资源利用效率不高。
- Exhibiting a high ratio of output to input. 功效大的产出与投入比值高的
- The ratio of hits to misses for the cache. 缓存命中数和未命中数的比率。
- volume ratio of stirrup 体积配箍率
- Length to diameter ratio of flexspline. 柔轮长度与内径之比。
