您要查找的是不是：
- radial pressure distribution 径向压力分布
- The internal stress distribution of the bead under interference fit and the pressure distribution at the bead rim interface were obtained by using 195/60R14 radial truck tire as example. 以195/60R14规格轿车子午线轮胎为例，获得了胎圈在过盈配合下的内应力分布及胎圈?轮辋接触面上的压力分布。
- Metal lacing eyelets for optimum fastening and pressure distribution. 最好加速和减压的金属网状小孔。
- This curvature of the flow field alters the pressure distribution and the aerodynamic forces from their values in translational flight. 流场的弯曲使压力分布和空气动力与直线飞行时的值相比发生了变化。
- The result shows that radial pressure obviously effect the dynamic strength and modulus, it is also big that the change of dynamic strength and modulus under different consolidation stress ratio. 试验结果表明，围压是动强度提高的重要影响因素，固结应力比不同的条件下，动强度及动模量变化也较大。
- In addition, the effect of startup pressure gradient of Bingham fluid in stratum pressure distribution are analyzed. 分析了宾汉流体的启动压力梯度对地层压力分布的影响。
- The analysis of the hydrostatic pressure distribution is beased on the momentum exchange equation of varying mass. 在动量恢复方程的基础上，分析了主流道的静压分布。
- In this paper, pressure distribution of gaseous slip flow in parallel plates microchannel was studied. 对平行平板微型槽中气体滑移流动的压强分布特性进行了研究。
- For the PTD flow field, this thesis first presents inviscid flow solution of evolved pressure distribution. PTD内部流场问题，先不考虑黏性进行计算，并讨论PTD内部在不同时间的压力分布。
- Flue gas flow model is established based on gas flow to research the pressure distribution along the width of furnaces. 运用气体流动相关知识，建立炉气流动模型，研究沿炉宽方向上的压力分布。
- The results show that the pressure distribution on external surface at both windward and leeward is basically the same. 结果表明：车体迎风面及背风面表面压力分布规律基本一致，验证了数值模拟计算模型的准确性；
- Firstly,the pressure distribution of gas solid flow along the circulating route is analyzed and experimentally studied. 分析气固两相流在循环路径中的压力分布，并通过试验对其进行了研究。
- The cone shape can be described by analyzing pressure distribution around a well. 通过研究近井的压力分布描述油井附近的水锥形态。
- The temperature and pressure distribution of the fluids along the pipeline and wellbore are calculated. 结果表明,随着地面注汽管线和井深的增加,过热蒸汽的过热度和压力明显下降。
- The fluid streamlines and pressure distribution and LZVV phenomena for the hydrocyclone are given in this paper. 计算得到了水力旋流器内的流线图、等压线以及零速包络面。
- The model is used to predict the subzonal pressure distribution in an area of an oilfield in combin... 应用该模型和生产测井资料对油田某区域某一小层的压力分布进行了预测;
- Mould flow and simulation should be carried out for the best gate location, filling analysis, pressure distribution and heat distribution. 适宜应用模拟的模具注塑过程,注射分析、压力分布及温度分布以确定最佳入水位置、流道尺寸和疏气位置等。
- Computational results showed that pressure distribution curve in parallel plates microchannel was convex decreasing parabolic curve. 模拟计算结果表明,平行平板间滑移流动的气体压强分布曲线是上凸的下降抛物曲线。
- Using above methods to solve unsteady pressure distribution, coupling structure equations, the supersonic or hypersonic aeroelasticity is simulated in time-domain. 运用上述的非定常气动力求解方法，耦合结构动力学方程，实现超音速、高超音速气动弹性的模拟。
- On the principle of minimum energy of network flow, the pipe pressure distribution is calculated, then the pipe split or leak due to excessive pressure will occur reductively. 根据网络流能量最小原理计算管压分布,从而减少了由于管压过高引起的水管裂缝或漏水。
