您要查找的是不是:
- pto shaft center line 动力输出轴轴心线
- The pump runs with an abnormal noise, could you check the shaft center lines between the motor and pump to see if they are aliened? 69这台泵运转的声音不正常,请检查一下电机和泵的轴线是否正常。
- Disconnect the implement drive line from the tractor PTO shaft. 从拖拉机动力输出轴上拆下工具传动系统。
- He drove straight by sighting along the center line. 他注视着中央线,驾车径直向前驶去。
- Put in the drawbar to the spindle shaft center hole. 将连接杆放在主轴中心孔。
- Deck height at center line, moulded. 中心线甲板型高。
- Hang the plumb on the shaft piano wire to measure the two distances which are between center line and the two edges of the M/E seat of the Fr 27#, Fr 33# and Fr37# respectively. 用在钢丝线上挂线锤的方法,记录27%23、33%23、37%23三档肋位处轴线对主机机座的分中数据。
- You're slightly off to the right of the center line. 你稍偏在中心线右面。
- Being in a position that is away from the center line of the hull of a ship. 舷外的位于偏离船体主线位置的
- QUENCHING CRACKING ANALYSIS OF PTO SHAFT OF TRACTOR 拖拉机输出轴开裂原因分析
- Abstract: The time-vibration waves and shaft center orbits, which contain rich information about the vibration failure of the steam turbine, have fractal characteristics. 文摘:包含丰富汽轮机转子振动和故障信息的一维时间振动波形和二维轴心轨迹图具有分形的特性。
- Where a solid yellow line is painted on your side of the center line. 当你所行的车道一侧中央是实黄线时。
- Under Line, select the options you want for the center line, and then click OK. 在“线条”下,选择所需的中线选项,然后单击“确定”。
- setting-out of cross line through shaft center 井筒十字中线标定
- A center line to which parts of a structure or body may be referred. 中轴结构物或人体的某些部分可被参照的中心线。
- White on toes and slim white snip on center line of face permissible. 身躯:柔韧,胸深差不多达到肘部。肋骨支撑良好。适度上提。
- To order, specify length from center line of valve to base of floorstand. 订购时,注明从阀门中心线至地轴承架底部的距离长度。
- Nutlets keeled abaxially along center line, with glochids usually only on keel. 沿着中线背面的给装龙骨的小坚果,带有钩毛通常只在龙骨上。
- When flanges are integral with fittings or valves, holes for bolts are drilled to straddle the center line. 如果法兰与连接件或阀门构成一个整体,则螺栓孔钻在圆心线两侧。
- To order, specify description and extension length from center line of valve to top of handwheel or nut. 订购时,注明描述信息和从阀门中心线至手轮顶部或螺母的加长长度尺寸。