您要查找的是不是:
- The results show that it is successful to adopt the technolngy of cold drawing with core mandrel for processing the propeller shaft tube s... 试验结果表明,采用短芯棒冷拔工艺加工传动轴管,在技术上是成功的。
- propeller shaft tube 传动轴轴套
- Nothing seems to be wrong with the propeller shaft. 转动轴看来没毛病。
- Reindex propeller shaft 180° and evaluate. 将传动轴翻转180°,并测试。
- Remove the rear propeller shaft. 拆卸后传动轴。
- Connect the vent hose to the axle shaft tube. 向主动轴管上连接通风管。
- Disconnect the vent hose from the axle shaft tube. 从主动轴管上断开通风管。
- Aligning intermediate shaft and propeller shaft after launching. 下水后中间轴和螺旋桨连接后校中。
- "The propeller shaft may be solid or hollow, protected by an outer tube or exposed. 传动轴可以是实心的或空心的,由套管加以保护或裸露在外。
- This measurement will give you the propeller shaft angle (C). 测量结果就是传动轴工作角(c)。
- Measuring clearance between propeller shaft &bearing. 螺旋桨轴与轴承间隙测量。
- Other goodies include a new limited slip differential, a final drive ratio of 3.71:1, and an alloy torque tube with a lightweight carbon-fiber propeller shaft. 其他的物品,包括一个新的限滑差速器,最终传动比的3.;71:1,和扭矩合金管轻质碳纤维传动轴
- Different nacelle with deeper ross-section and intake over propeller shaft. 发动机舱、螺旋桨轴处的进气口有一些不同。
- Clean axle shaft tubes and oil channels in housing. 清洁驱动桥轮轴底盘和壳内油路。
- Install the straps and bolts to hold the propeller shaft to the yoke. 安装扣夹和螺栓,将传动轴固定到轴轭上。
- Align previously made marks on yoke and propeller shaft and install propeller shaft. 将定位轭架上的预制标记对准传动轴并安装传动轴。
- Mark the propeller shaft and pinion yoke, or pinion flange, for installation reference. 在传动轴和传动轴轴轭、或小齿轮轴轭上作标记,作安装的参考标志。
- Align the installation reference marks on the propeller shaft and yoke and install the propeller shaft. 对准传动轴和轭上安装参考标记,安装传递轴。
- A typical slip joint consists of a hardened, ground splined shaft welded to the drive shaft tube that is inserted into a slip yoke that has matching internal splines. 一个典型的滑关节有一变硬, 地面装以角栓被焊接到被进入一个一直相配内在的云形规的滑轭之内插入的驱动轴管的桥了。
- The forging and deep extrusion compound process for axle shaft tube was introduced,and the process was applied to the high-energy screw press and hydraulic press respectively. 介绍了一种半轴套管锻造及深孔挤压复合工艺,该工艺分别在离合器式高能螺旋压力机和液压机上进行锻造和深孔挤压成形。