您要查找的是不是：
- Three study methods are used in the paper, including the critical production empirical formula, the producing pressure drop and numerical simulation. 根据动态数据采用临界产量经验公式法、生产压差分析法和数值模拟等几种方法计算对比,分析了研究区的各井生产情况,确定了各井的合理产量。
- producing pressures drop 生产压差
- Keywords Wenmi oil field;fluid productivity index;productivity index;actuating pressure gradient;producing pressure drop; 温米油田;采液指数;采油指数;启动压力梯度;生产压差;
- producing pressure drop 生产压差
- Watch pressure drop on pressure gauge. 手表压力在压力标准度量上降低。
- Valve exhibits high pressure drop. 阀门出现高压降。
- DID THE PRESSURE DROP TO 0 PSI AND A "NO DRIVE" CONDITION OCCUR? 压力是否降至0PSI而且条件"NO DRIVE"出现?
- However, the pressure drop occurs almost completely in the plug. 然而，压力降几乎完全发生在多孔塞中。
- Drier operates in either flow direction with low pressure drop. 在任何一方向都可操作应用。
- Presents the theoretical model of pressure drop for flexible duct. 摘要介绍了柔性风管压力损失的理论模型。
- They are commonly used where a minimum pressure drop is important. 通常用在要求压降最小的应用场合。
- Read the pressure drop across the valve with a Watts Series PG meter. 利用美国瓦茨系列PG仪器读出通过阀门的压降。
- For compressible fluids, where pressure drop exceeds half the inlet pressure. 对于可压缩性流体,如果压降超过进口压力的一半。
- Inspection equipment for producing pressure containers, such as tensile ,compression and universal testing machine ,impact machine ,X-ray defectoscope. 抗拉、抗压、万能试验机、冲击机、X光拍片射线探伤机等制造压力容器检验设备。
- For non-compressible fluids, where pressure drop causes cavitation or flashing. 对于不可压缩性流体,如果压降产生空穴或闪蒸。
- Wuyi Xiangtai Utensils Co., Ltd. specializes in producing pressure cooker and coffeepot etc products, the products have been psaaed the certificate of CCC, CE and GS. 武义祥泰器具有限公司专业生产压力锅和咖啡壶等产品，产品通过3C、CE、GS认证。
- Adjust balancing valve until pressure differential gauge reads pressure drop required for desired flow rate gpm. 调整平衡阀直到压差表读出压降符合所要求的流量（加仑/分钟）为止。
- The inventory of solids in a fluidized bed can easily be found by pressure drop measurements across the bed. 流化床内的固定藏量可以用测定床层的压降办法很容易地求得。
- The retrograde condensation impact tends to be unavoidable because the phenomenon that bottomhole producing pressure is lower than dew point pressure is easy to be found in productivity well test. 而在产能试井中很容易出现井底流压低于露点压力的情况，因此反凝析现象不可避免。
- Requirement: Supply pressure drop must be 1.0 PSID or more when water flow stops from test cock No. 2. 要求：当水流从测试旋塞2号上停止时，供应压降必须在1.;0PSID及以上。
