您要查找的是不是：
- The results showed that results of theoretical simulation calculation of pressure between rolls basically corresponded to that by three-dimensional photoelasticity stress test... 结果表明;理论模拟计算的辊间压力与三维光弹性应力实验分析结果基本吻合;平均相对误差<8%25。
- An Analysis on Distribution of Pressure Between Rolls of HC Mill HC轧机辊间压力分布的分析
- ANALYSIS ON THE CONTACT PRESSURE BETWEEN ROLLS OF ROLLING MILL 辊间压力分布影响因素的研究
- Roll deformation rule of varying contact length back-up roll under the condition of equal contact pressure between rolls 变接触长度支承辊间等接触压力时轧辊变形规律
- pressure between rolls 辊间压力
- The pressure between the anilox roll and die plate is adjustable with springs .Wiper roll adopts eccentric adjusting and locking mechanism. 网纹滚与字模板压力采用弹簧调整，传墨滚采用偏心同步调整并设有锁紧机构。
- What is the relation between Roll() and the number of sides on the die? Roll()和骰子上的面数之间的关系是什么?
- Install top layer (Pre-fabricated black rubber shred roll sheet) in one direction. Gaps between roll sheets can allow material expansion. 同一方向铺设表层（黑橡胶粒预制板）。板间为材料的胀缩留下缝隙。
- When supply pressure drops to atmospheric, air break must relieve pressure between both checks. 当供应压力下降到大气压力时,空气开关节点必须释放两个止回阀之间的压力。
- Hurricanes are typical of a calm central region of low pressure between 12 to 60 miles in diameter, know as the eye. 飓风的特征是其中心的无风区域，那里的气压低，直径在12到60英里之间，被称做风眼。
- Back pressure The squeeze pressure between the blanket (offset) cylinder and the impression cylinder, Also called Impression pressure. 胶布圆筒(柯式机)和压力圆筒间因紧压而产生的压力。亦称压印力。
- Also, the difference in pressure between any two points in a bed is roughly approximated by the static head of bed between these points. 还有，床层中任意两点间的压差大致等于这两点间床层静压头。
- Systolic blood pressure is the pressure found when the heart pumps, in contrast to diastolic blood pressure, the pressure between heart beats. 收缩压是心脏泵入时的压力，对应心脏搏动间的压力，舒张压。
- Two-way ANOVA demonstrated a significant difference in systolic blood pressure between the placebo group and the 3.6 mg VPP plus IPP group (P <.001). 双向ANOVA检定发现相较于安慰剂组、以及接受3.;6毫克VPP加上IPP自愿者，收缩压明显地下降（P＜
- In the film covering based substrate to adjust the thickness of the paper silican drum and the pressure between the steel drum. 在覆膜时应根据承印物纸张的厚度来调整硅胶滚筒和钢滚筒之间的压力。
- Vacuum may be thought of as the absence of pressure. It is the measure of negative pressure between standardized atmospheric pressure and a theoretically perfect vacuum. 真空可以被认为缺少压力。真空是以标准大气压的负压和理论完全真空来测量的。
- In the finite element simulation, when the pressure between the punch and blank rise to peak, strain of the thinnest element in the blank is the necking limit . 有限元仿真中,凸模与板料接触力出现峰值的时刻,板料上变薄量最大单元的邻近单元应变即是材料的缩颈极限应变,通过改变试件形状及尺寸就可以得到在不同应变状态下的缩颈极限应变。
- Three general systems for solid upper floors in use nowadays are: Plain or reinforced concrete filling between rolled steel joists (r. s. js.) as shown in Fig.5. 目前大致使用以下三种类型的实心上层楼面：在热轧工字钢梁之间添加素混凝土或钢筋混凝土,如图5所示。
- The different expansion joint set in lining-up BOF will lead the different of contact pressure between lining and shell,and further produce different thermal-stress. 转炉炉衬砌筑时设置的膨胀间隙不同会导致炉衬与炉壳之间的接触压力不同,进而导致炉衬的热应力不同。
- By using concretes instead of lead-zine alloys as adherend between rolling mortar wall and adjustable ring,a good effect has been achieved. 使用沙浆混凝土代替铅锌合金浇入轧臼壁与调整环之间作粘附物,取得了较好的使用效果。
