您要查找的是不是:
- piston valve body 活塞阀体
- Kits include: Rubber Disc, Piston Diaphragm Assembly, disc retainer, Relief valve body O-ring. 组件包括:橡胶阀瓣,活塞隔膜总成,阀瓣固定器,安全阀阀体O形环。
- Remove the body bolts from the valve body. 从阀体上拆卸阀体螺栓。
- Lift retainer and check assembly from valve body. 从阀体内取出护圈和止回阀总成。
- Screw the cover onto the valve body. 将阀盖旋在阀体上。
- Chemical analysis and mechanical tests on the materials used for inlet valve body, disk, trunnions, servomotor cylinders, piston rods, upstream and downstream piping. 对用于进气阀阀体、阀盘、耳轴、伺服缸、活塞杆及上下游管道的材料进行化学分析和机械测试。
- Turn handle to be perfectly perpendicular to valve body. 将手柄旋转到与阀体完全垂直的位置。
- Remove the body bolts from valve body using Allen Key. 采用内六角扳手从阀体上拆卸阀体螺栓。
- Installation suggestion: valve body vertical and upward. 建议安装方式,阀体垂直向上。
- IMPORTANT! Flow must always be in direction of arrow on valve body. 重要提示!水流流向必须与阀体上的箭头方向一致。
- Insert valve body through mounting hole and seat lugs. 将阀体插入安装孔和密封连接盘。
- Press stem/ball into valve body and remove from open end. 将阀杆/球体压入阀体内,并且从开口端卸下来。
- The top of retainer must drop just below threads in the valve body. 护圈上方必须放置在阀门阀体螺纹以下。
- Slide one half of the splash guard into the groove on the relief valve body. 将防溅保护的一半滑动到安全阀阀体的沟槽上。
- Install valve in the direction of the flow arrows on the valve body. 按照阀体上的箭头方向安装阀门。
- Assigning the ideally fitted wedge, ground and lapped, to proper valve body. 将研磨后的楔板分配到最适合的阀体上。
- sleeve with piston valve, trocar 带活塞阀门的套管针外套
- Reinstall the valve body and union nuts only after the joint has fully cured. 只有在连接完全成功粘固后,才能够重新安装阀门阀体。
- All the apprentices rushed to help fit the piston. 徒工们都跑过来帮助装活塞。
- Get lathe No.9 set to turn the new piston. 把九号车床调好来车这个新活塞。