您要查找的是不是:
- Enter 0 for main pressure tolerance plus. 主压力正公差输入0。
- Activate the individual selection main pressure. 激活单个选择的主压力。
- Note the current main pressure actual value. 记录当前主压力的实际值。
- Enter 50% for main pressure tolerance plus and tolerance minus. 主压力正负公差输入为50%25
- Select "with filling" at the main pressure regulation. 选择“物料”调节主压力。
- Note the set value for compaction force main pressure. 记录主压力设定值。
- Thus it was demonstrated that the main pressure zone was little affected by the downstream flow condition. 由此可见,下游的流动情况对主要压力区几乎没有影响。
- Direct connection to mains pressure water supply is not permitted. 严禁直接连在有压力的供水装置上。
- The punch diagram displays that the increased compaction force main pressure will be regulated to the set value. 冲杆图表显示主压力增加校准设定值。
- Enter a value for main pressure set value that is approximately 10% higher than the displayed revolution average value. 输入一个主压力设定值,大约比旋转平均值高10%25。
- Enter a value for main pressure set value that is approximately 10% lower than the displayed revolution average value. 输入一个主压力设定值,大约比旋转平均值低10%25。
- The revolution average value displays that the compaction force main pressure exceeds the set value. 主压力旋转平均值超过设定值。
- Pay attention that the main pressure set value does not exceed the tolerance limit plus. 注意主压力设定值不能超过正公差。
- Pay attention that the main pressure set value does not fall below the tolerance limit plus. 注意主压力设定值不能低于正公差范围。
- Start the tablet press and keep it running until a new current revolution average value for main pressure is displayed. 启动压片机保持运行直到当前新的旋转主压力平均值被显示为止。
- Air pressure forces the water through the pipe. 空气压力使水通过管道。
- A new value is entered at punch load that is below the value of compaction force main pressure. 在冲压加载主压力下输入一个新压力值。
- Adjust the tolerance limits of the main pressure in such a way that the pressure of the prepared punch lies within the tolerance limits. 调整主压力的允许范围,这时准备好的冲杆压力应在允许范围内。
- I told her to pipe down but she still babbled on. 我叫她闭嘴,可她还是唠叨个没完。
- The pipe burst and a spout of water shoot out. 水管破裂了,一股水喷了出来。