您要查找的是不是:
- Maximum motor start current under full voltage start conditions is defined by the motor‘s Locked Rotor Current (LRC). 全电压起动条件下最大电机起动电流是由电机锁定转子电流(LRC)确定的。
- Internal circuit protection includes thermal shutdown with hysteresis, under voltage lockout, locked rotor and dead time protection. 内部电路保护包括因滞后引起的过热关机、欠压锁定、转子锁定以及停机时间保护。
- Mr. Smith prefers that you remain at Lock Willow. 史密斯先生希望你留在洛克威洛。
- All components must be rated for peak voltage and current. 所有期间的额定值都必须达到峰值电压和电流。
- peak voltage at locked-rotor 峰值堵转电压
- MEASURE THE VOLTAGE AT THE TRANS RELAY CONTROL CIRCUIT AT TCM. 测量TCM的变速继电器电路的电压。
- The input voltage at which the output logic level changes state. 输出逻辑电平改变状态时的输入电压。
- Motor start torque performance is indicated by the motor‘s Locked Rotor Torque (LRT) figure. 电机起动扭矩性能是由电机的锁定转子扭矩(LRT)图表示的。
- The power MOSFET suffers a peak current of IIN plus IF and a peak voltage of VIN plus VO. 功率MOSFET要承受一个峰值为IIN加上IF的电流还有一个峰值为VIN 加上 VO的电压。
- It also includes, Hall element inputs, a sequencer for commutation control, fixed off time pulse width modulation (PWM) current control and locked rotor protection. 它还包括霍尔元件输入、整流控制定序器、固定停机时间脉冲宽度调制(PWM)电流控制以及锁定转子保护。
- Analysis of the Accident of Looping Arc in Steel Mill DC Motor Resulting from High Peak Voltage between Commutator Bars etc. 片间峰值电压高等原因引起轧钢电动机环火事故分析
- Knowing a member of the Pendleton family is the best introduction one can have at Lock Willow. 在洛克威洛,认识彭德尔顿家的一个成员是最好的引见。
- The system with signal peak voltage holding, A/D converter, microprocessor, D/Aconverter and voltage adjustment was introduced to realize the ultrasonic signal AGC. (3)采用自动增益控制,即信号的峰值电压经A/D变为数字信号送给单片机,再通过D/A和电压调节电路调节增益控制电压,实现测量信号的自动增益控制。
- For comparison, most charged particles discharged in a nuclear explosion range between 0.3 and 3 MeV, while diagnostic medical X-ray has peak voltage around 0.5 MeV. 作为比较,绝大多数带电粒子在一场能量范围在0.;3到3兆电子伏之间的核爆炸中放了电,而诊断性医学X射线的最大电压是0
- In order to increase the output peak voltage of pulser, Marx circuit is used, and its structure is designed for strict comb PCB(printed circuit board) layout. 梳状PCB(印刷电路板)电路是一种结构紧凑具有自相似性的电路形式,有利于进一步提高脉冲源的稳定度指标,也有利于脉冲源的小型化设计。
- To make invariable electric current in the conductor, there must be certain voltage at two ends of the conductor. 要使导体中有恒定电流,必须使导体两端保持有一定的电压。
- The experimental setup can output the pulse voltage with 3ns risetime and 330kV peak voltage using the co-axial capacitor fitted with high pressure gas gap. 利用这一峰化电容器并与高气压小间隙陡化开关配合,在该实验装置上得到了前沿(10%25-90%25)3ns,峰值330kV的脉冲电压。
- If the voltage at the capacitor would be too high during light load, some or all of the capacitors are switched off. 若轻负荷时电容器上电压太高,就切除一些或全部电容器。
- The amount and direction of power flow may be easily controlled by adjusting the DC voltage at the two terminals. 通过调节两换流终端站的直流电压可以容易地控制潮流的数量和方向。
- The harmonic voltage at zero power test of Longquan HVDC converter station is calculated. 摘要计算了龙泉-政平HVDC工程龙泉站系统试验期间零功率试验时的谐波电压。