您要查找的是不是：
- I had thought that ML should be added after the ferment had hit peak temperature but was still ongoing. 我原以为应加毫升发酵后气温曾达到高峰,但仍在继续。
- The main difference when using tin-silver-copper as the paste alloy will be the peak temperature. 将锡-银-铜作为焊锡膏合金时的主要差别在于峰值温度。
- The expressions of the relations among laser power, scanning speed, and harden layer, peak temperature are obtained. 通过分析激光工艺与硬化层深度和表面峰值温度的关系，确定出激光功率和扫描速度对硬化层深度和表面峰值温度的经验关系表达式。
- Significant positive correlation exist between gelatinization peak temperature and heat enthalpy. 热力学参数顶点温度与热焓值间存在较大的正相关性。
- The peak temperature of the wood powder with higher MC was smaller with the same heating rate. 在相同升温速率条件下，含水率高的木粉出峰温度低，峰的终止温度低。
- Change of carbon addition from 2mol to 4mol was found to have little effect on the peak temperature of Ti3O5 and Ti(C,N). 在FeTiO3-xC-2Fe体系中，碳加入量的变化对Ti3O5和Ti(C,N)形成的吸热峰峰值温度影响不大，前者保持在1156℃左右，后者保持在1360℃左右。
- The results shows that the addition of nucleating agents increased the onset temperature and peak temperature and improved crystallization rate of PP. 结果表明，两种成核剂的加入均可提高聚丙烯的结晶起始温度和结晶峰温度，并加快结晶速度。
- Thermal properties and morphology of crystal in Nylon 1010 formed isothermally at melting peak temperature were studied through DSC,TEM and ED. 用DSC、TEM、ED研究了尼龙1010在熔融峰温等温结晶生成晶体的热性质和形态结构。
- The physical meaning of the initial temperature and the peak temperature determined by DSC extrapolation has been con firmed through variance analysis. 通过对比实验的方差分析探讨了DSC法外推起始温度及峰值温度的物理意义。
- Optimizing the thermal profile to reduce peak temperature and time to the lowest level possible will improve cleanability. 合理优化再流温度曲线，将峰值温度及其持续时间降至最低水平将有助于提高清洗能力。
- The results show that, with increasing Y2O3 content, the crystallization peak temperature rises and the peak band becomes broader and blunter for this system glass. 研究结果表明：随着Y2O3含量的增加，玻璃的析晶峰值温度升高，且析晶峰也逐渐变宽、变钝；
- There are several types of burners. The picture shows a Teclu-Burner. Each type has specific uses. They vary in the peak temperature and overall heating capability. 燃烧器有很多种。图片中的是特克卢燃烧器。每种燃烧器都有特定的用途。它们的最大温度都可调而且加热均匀。
- Computational result show that the porosity increases with the smolder progression,consequently the smolder propagation rate and its peak temperature will be raised. 对上方具有空气掠过的水平纤维质填充床,从点火到稳态传播的阴燃过程进行了模拟计算。
- With the increase of trimesic acid during polymerization, the main peak temperature in DSC curve decreases gradually, while the crystallinity increases at first, th... 随聚合过程中苯三甲酸含量的增加,聚合物主峰的温度逐步下降,而结晶度的变化是先升后降再升。
- The TG results show that vitrinite has higher volatile matter yield, maximum weight loss rate and lower initial decomposition temperature and peak temperature than that of interinite. 结果表明:镜质组比惰质组有较高的挥发分收率和较高的最大失重速率;较低的起始热解温度和热解峰温.
- The thermoluminescence strengths and peak temperatures of beryls can be regard ed as the typomorphic characteristics. 绿柱石的热释光强度和峰温可作为其标型特征之一。
- Under the same heating rate, the crystallization temperature of Ni P UFD composite coating is lower than that of Ni P coating, while the peak temperature of the two electroless coating are well matched. 在相同的加热速率下 ,Ni P UFD复合镀层晶化的起始温度均低于Ni P镀层 ,但峰值温度与Ni P镀层相当 ;
- The results showed that the HAZ impact toughness decreased with the increase in peak temperature and hence the fractographic appearance changed from dimple pattern to cleavage or quasi-cleavage pattern. 结果表明,随着峰值温度的提高,冲击韧性下降,断口形貌由韧窝状变成解理或准解理状。
- Pin-testable flux residues remain soft after reflow and will be pin-testable, the flux is designed not to harden at the higher peak temperatures. 可探针测试残留物回流后依然保持柔软状态,因而可以使用探针测试,该种焊剂在较高的峰值温度下不会变硬。
- If tin-silver-copper solder paste is used the peak temperature will be higher, if the flux formulation is not designed for higher temperatures removal may be more difficult. 如果使用锡-银-铜焊锡膏,则峰值温度将会较高,如果焊剂配方不适用于较高温度,则残留物的清除难度将会变大。
