您要查找的是不是：
- Keywords gantry machining center;parameter of contact surfaces;dynamic design;tuned damper; 龙门加工中心;结合面参数;动态设计;调谐阻尼器;
- parameter of contact surfaces 结合面参数
- Keywords Gantry machining center;Parameters of contact surfaces;Dynamic simulation;Structure optimal design; 龙门加工中心;结合面参数;动态仿真;结构优化设计;
- Microscopic particles of airborne dust settle on metallic portions of contact surfaces. 空气中的细微灰尘会堆积在接触面的金属部分。
- To" lubricate" means to reduce the frictions of contacting surfaces in machinery components. 润滑是为了减少机器零件接触表面的摩擦。
- The concrete is composed of hick aggregates, cement mortar and caking belt of contact surface. 摘要混凝土是由粗骨料、水泥砂浆及界面粘结带组成的复合材料。
- To "lubricate" means to reduce the frictions of contacting surfaces in machinery components. 润滑是为了减少机器零件接触表面的摩擦。
- The experiment certifies that the result of two-stage analysis in the research can improve the flatness of contact surface 86.5% effectively. 经由实验验证可知，本研究所提出的两阶段分析方法，其结果可以有效提升贴合面平坦度86.;5%25。
- Superplasticity in a complex shape parts, the die surface of contact surface friction will limit further deformation region. 在复杂的超塑性零件的成形中，硬模表面的摩擦将限制接触面区域的进一步变形。
- Parameters of contact layer are determined when deformation of contact layer is equal to initial gap which is proposed in the criterion of penstock. 另外，接触层参数可通过其变形与规范建议的初始缝隙相匹配的原则加以确定。
- The point of contact of two abutting objects or parts. 接合点，结合器两物或两部分相接的那一点
- Jitter is an important parameter of VoIP QoS. 在提供IP电话服务时,时延抖动是一个重要的QoS参数。
- Set up the parameter of process. Execute the PM. 设定制程参数，按保养计划保养波峰焊机台。
- The better bond performance is due to larger bore diameter of the porous oxide film, higher porosity density, i.e., the bond performance improves with the increase of contact surface area. 良好的胶合性能因多孔质型氧化皮膜孔径较大、微孔密度较高，即接著面积增加，则胶合性能也随之上升。
- It is the parameter of distribution. 这就是分布参数。
- I left a message so as to be sure of contacting her. 我留下了张条子以便与她取得联系。
- This condition may be the best parameter of PIV. 这是PIV系统的最佳工作条件。
- I have is out of contact with her for three year. 我与她失去联系已有三年。
- The helicoid equation of contacting surface befween workpiece and die in the process of cross wedge roiling was proposed in this paper. 建立了楔横轧变形工件与模具接触面的旋转螺旋面方程。
- Output two teams of contact signal. 输出两组触点信号。
